2320 75TH ST SW 2018-01-02 MF Import

COMPUANCE REQUIRED INSPECTION INIPORTANT: 110-N-OT place checks In the two left columns. APPROVED _.* C:] ❑ 0 Exposed foam Insulation shall comply as follows (S. 502.1.4.7): ❑ Protected with metal or plastic flashing, or other suitable material that extends below grade. ❑ In :ulation is approved for sub-grado, exterior use and properly installed. O O QAlrfiow between trosh air ports and the wholo-house Ian ensured by undercut doors!g6lis(VIAC,S. 302.d.4) IO O ®Looseflll Insulation QK if (S.502.1.4.5): ® maximum telling slope not > 3 in 12ing at M: 30" of clear distance from top of bottom chord to underside ofroof 1nd extend lto foundation waldl ge Ell s 6 mll black polyethylene ground cover, shall be lapped 12" at I" E3 El gClearances shall meet listed minimums between insulation and 02.1.4.3): a chimney ❑Non -IC rated recessed lights: 1/2" to combustables, 3" to insulation. CI El z Attic batch shall be insulated to required ceiling R-value and is weatherstripped (S.502.1.4.4) O O s Attic access shall have wood dam or equivalent to retain loose fill insulation in attic(S. 502.1.4.4) a C s All exterior doors (except 20 minute doors) shall be weatherstripped (S. 502.4.3). 503.11 CO ED a Service hot & cold water piping in unconditioned spaces shall be insulated to R-3( ) L� � r Service hot& codrecirculation hot water piping in unconditioned spaces steal: be insulated to Table 5-12 levels. n O 2 Heat pump thermostat shall have progamable capability (F. 503.8.3.5) S.503.6.1.1 0 0 hermostat proviced for each HVAC system with range of _5.75' F.(healing) ( ). C7 0 Readily accessible, automatic or Manual means provided to restrict or shut -oft Heating input to each zone or floor during periods not requiring heat (S. 503.8.3.1). p E3 s ontrols for backup heat prohibit similtaneeoups operation of the primary system stem, (S 503.2.2(3)). 0 .2 2(3)) O O s echanlcal vent] system shall have proper timers, and/or switches ( VIAm, ). 302.5) z echanlcal ventilation ducts shall have R-4 insulation in unconditioned spaces O O I ducts in rondiliDaed spaces shall have R-4 insulation (VIAO, 302.5) O s echanlcal ventilation supply O O s upply ducts ;hat have volume dampers, or the equivalent, to balance system (S. 503.6). C) p a��upply and return air ducts shall havesealed duct joints in unconditioned spaces (S. 503.10.2). 0 O i VAC plenums, supply, and return air ducts shall have R-8 insulation (Table 5-11, All options) E:] 2 lectric water heater(s) shall have (S. 504.2.1, 504.3, 504.4) O ❑ separate power shut -oft 1987 NAECA Lable on tank ❑ noncompressibte R10 pad (unheated spn^es only) ❑ Temperature setting s 120 F. I C C3 @DShowers and lavatories shall limit flow to s 3.0 gallons/minute (S. 504.8.1). O O ®Swimming pools(S. 504.5) shall have: eater) ❑Pool cover ❑Piping insulated to S. 503.11 ❑ readily accessible ON/OFF switch (pump, h a ED @DAII fireplaces (VIAO, S. 402.3) shall have: M 6 square inch combustion air supplyduct w/ accessible damper directly connected to the Lire box i Tight fitting glass or metal doors. ❑ Tight fitting flue damper a p s)Solid fuel burning appliances) (VIAO, S. 402.2) shall have: C]Tighl fitting glass or metal doors 00utside combustion air source directly connected to the fire box p[zception: Non direct, 4' diameter, dampered, combustion air source: allowed only for (1) new stove installations in existing homes where obshuctionsprecludes direct combustion air, or (2) Central healing systems located in unheated spaces. Three month, etched track radon monitor, p(Vrinted instructions, and information sheets shall supplied p O f multi family dwellings by ,he general contractor (VIA to the single family dwelling or first floor units o 502.2.1), _ WSEC Final phase requirements: pare_ Inspected by - _-- Page 6 of 6