914 90TH ST SW 2018-01-02 MF Import

COMPLIANCE REOU:RED V M INSPECTION IMPORTANT: Disregard topics that don't describe your building or equipment. DO NOT APPROVED place checks In the two left columns. PHASEFINAL (Conflnued) ❑ ❑ 0 Airflow from habitable rooms to whole -house fan ensured by undercut doors or grills (VIAO, S. 302.6.4) ❑ ❑ ®i Looseflil Insulation OK If (S.502.1.4.5): ❑maximum ceiling slope <3 in 12 ❑a 30" of clear distance from top of bottom chord to underside of roof sheathing at the roof ridge. ❑ ❑ Q6 mil black polyethylene ground cover, lapped 12' at joints and to foundation wall ❑ ❑ ©Clearances shall meet listed minimums between insulation and (S.502.1.4.3): ❑ chimney ❑ Non -IC rated recessed lights: 1/2" to combustables, 3" to insulation. ❑ O Attic hatch shall be insulated to required ceiling R-value and is weatherstripped (S.502.1.4 ') ❑ CI Attic access shall have wood dam or equivalent to retain loose fill Insulation in attic (S. 502.1.4.4) ❑ O e II exterior doors (except 20 minute doors) shall be weatherstripped (S. 502.4.3). ❑ ❑ FReadilyervice hot & cold water piping shall be insulated to R-3 (S. a03.11) ❑ ❑ervice recirculation hot water piping shall be Insulated to Table 5-121evels. ❑ ❑hermostat provided for each HVAC system with range of 55-75' F(heating) (S.503.8.1.1). ❑ ❑ accessible, automatic or Manual means provided to restrict or shut-off Heating Input to each zone or floor during periods not requiring heat (S. 503.8.3.1). p ❑IE ontrols for backup heat prohibit similtaneous operation of the primary system (S. 503.2.2(3)). ❑ ❑echanical ventilation systems shall have proper timers, and/or switches (S. 302.3). ❑ ❑echanical ventilation ducts shall have insulation a R-4 in unconditioned spaces (VIAO, S. 302.5) ❑ ❑echanical supply ducts in conditioned spaces shall have a R-4 insulation (VIAO, S. 302.5) ❑ . ❑upply ducts shall have volume dampers, or the equivalent, to balance system (S. 503.6). ❑ ❑upply and return air ducts shall have sealed duct joints in unconditioned spaces (S. 503.10.2). ❑ ❑VAC plenums, supply, and return air ducts shall have R-8 Insulation (Table 5-11, All options) ❑ Olectric water heater(s) shall have (S. 504.2.1, 504.3. 504.4) : ❑ separate power shut-off ❑ 1987 NAECA Lable on tank ❑ noncompressible R10 pad (unheated spaces only) tr • Temperature setting s 120 F. ❑ ❑howers and lavatories shall limit flowto s 3.0 gallons/minute (S. 504.8.1). ❑ ❑wimming pool(s) (S. 504.5) shall have: ❑readily accessible ON/OFF switch (pump, heater) ❑Poolcover ❑ Piping Insulated to S. 503.11 ❑ ❑lreplace(s) (VIAO, S. 402.3) shall have: ❑ 6 square Inch combustion air supplyducl w/ operable damper, directly connected to the fire box ❑ Tight filling glass or metal doors; or flue draft induction tan. ❑ Tight fitting flue damper. ❑ Oolid fuel burning appllance(s) (VIAO, S. 402.2) shall have: ❑ Tight fitting glass or metal doors r3 Outside combustion air source directly connected to the fire box ❑ Exception: Non -direct, 4" diameter, dampered, combustion air source: allowed only for (1) new stove Installations In existing homes where obstructions preclude direct combustion air, or (2) Central heating systems lucated in unheated spaces. ❑ O 9 Three month, etched tra :k, radon monitor, printed Instructions, and an Information sheet shall be supplied by the builder to each single family dwelling and to each ground floor unit of multi -family dwellings (VIAO, S. 502.2.1). Final phase requirements:rW�SEC pected by: Date_ __j Page 6 of 6