Laserfiche WebLink
COMPLIANCE <br />REQUIRED Gr <br />70 <br />K <br />R <br />0 <br />E D supply APPROVED IMPORTANT: Pleaseply Information In the shaded boxes and check the appropriate <br />APPROVE <br />Circles. Disregard topics that don't describe your building or equipment. DO NOT place <br />checks in the two left columns. <br />❑ <br />© Exterior slab Insulation, if not located on the interior, shall be R-10 (Table 6-1) <br />❑ <br />©i Exterlor slab Insulation material, if present, shall be approved for below grade use. <br />❑ <br />fe Walls, Incloding rim joists, Shall be insulated without compression to (Table 6-1): <br />0R-21 Batt (Options I,III,V,VI) KKR-19 (Option11, IV) OR-19+85 foam (Options VII,VIII) <br />❑ <br />Qlnterior below grade walls shall be Insulated to (Table 6.1): <br />0 R-21 (Options I, III,V,VI,VII,VIII) 0 R-19 (Options tl, IV) <br />❑ <br />QVaulted ceilings shall be insulated without compression to (Table 6-1) R-30 (All options) <br />❑ <br />QSkyllght wall Insulation is installed and equivalent to the required wall R-values above. <br />❑ <br />s Vapor retarders shall be Installed toward the warm surface as represented below (5021.6): <br />Select one option for floors, walls, and appropriate ceilings: <br />Floors: } Plywood W/ exterior glue 0 Poly (i 4 Mil) 0 backed baits <br />Walls: Poly plastic (a 4 Mil) 0 Face -stapled, backed bads _ OPVA paint <br />g <br />Ceilings: Not required where ventilation space averages >12" above I sulation. <br />0 Face stapled backed batts 0 Poly plastic (a 4 mil} 0 PVA paint <br />❑ <br />Heating system efficiency and sizing requirements shall be met as represented below: <br />❑ <br />®Maximum heating system output (150%of design heat load) is KW (S.503.22) <br />❑ <br />Qs Heating system requirements will is met with the fallowing system (S.503.4.1.1)t <br />Mir. Model p— _Max. output ION <br />Type <br />WSEU Insulation phase requirements: <br />Inspected by Date <br />FINAL 16HAk <br />❑ <br />© Envelope Floors shall be insulated without compression, and with support s 24" O.C. to R-30 (till <br />❑ <br />Options, Table 6-1). <br />Qi Non-vautted, attic ceilings shall be insulated without compression io R-38 (Ali Options, Table 6-1) <br />❑ <br />Q Door systems shall meet: 0 U.40 (Options I, III) 0 U.20 (Options 11, IV, V, VI, VII, Vill, Table 6-1) <br />Door types are (1j _(2)-- (3)--- <br />❑ QExposed foam Insulation shall comply as follows (S. 502.1.4.8): <br />p Protected with metal or plastic flashing or equivalent material that extends below grade. <br />Page 5 of 6 <br />