6101 ASSOCIATED BLVD BASE FILE 2017-06-05

2. Access-O.K.as shown on the site Supplemental Map prepared by David Evans and Associates, Inc. dated November 2011. 3, Two (2) Knox Boxes are required—to be located at alarm/sprinkler room area for each building. 4. Fire Lane Marking(ner field review) -Fire apparatus access roads shall be marked whenever necessary to maintain the unobstructed minimum required width of roadways: Fire lanes shall be marked as follows: a. Curbs shall be identified by red traffic paint with a 6-inch wide stripe on the top and front, extending the length of the designated fire lane. b. Rolled curbs shall be identified by red traffic paint with a 6-inch wide stripe on the curb, extending the length of the designated fire lane. C. Lanes without curbs shall be identified by red traffic paint with a 6-inch wide stripe on the pavement,extending the length of the designated fire lane. d. The words'NO PARKING-FIRE LANE'shall be in 3-inch stroke white letters 18 inches in height,and placed 8 inches measured perpendicular from the red paint stripe on the pavement. In most cases,both sides of the access road shall be marked. Where long drives are to be marked,the repetitions shall alternate sides of the drive. e. Marking shall also.include the addition of metal signs stating'NO PARKING-FIRE LANE-TOW AWAY ZONE-EMC 46.28.130'to be installed at intervals or locations designated by the Fire Code Official. The signs shall be approximately 12 inches in width and 18 inches in height and have red letters on a white background. Metal signs shall be installed on either 2-inch metal pipes for private property or treated 4-inch by 4-inch wood posts for public property and shall be located so that the bottom of the sign is a minimum of 7 feet above the curb. Where fire lanes are adjacent to buildings or structures and when approved or directed by the Fire Code Official,the signs may be placed on the face of the building or structure. f. Where directed by the Fire Code Official,specific areas shall be designated and those areas are to be marked with diagonal striping across the width of the fire lane. Diagonal marking shall be used in conjunction with painted curbs and/or edge striping and shall run at an angle of 30 to 60 degrees from one side to the other. These diagonal lines shall be in red traffic paint,parallel with each other,at least 6 - inches in width and 24 inches apart. Lettering shall appear as above. S. Fire Hydrants -Locations as planned are acceptable. 6. A fire hydrant shall be located within 10 to 75 feet of a fire department connection or standpipe per 2009 IFC,Section 903.3.7. 7. Fire flow for this project is 4,000 gpm. 8. When the required fire flow is over 2,500 gpm,the fire hydrant shall be served by a main that loops around the building or complex of buildings and reconnects back into a distribution supply main. 9. Portable Fire Protection-A portable fire extinguisher with a minimum U.L.rating of 17