2814 HEWITT AVE 2017-05-24 - Laserfiche WebLink

I Type I hoods to the outlet terminal, per IMC Section 506.3.10.2. The manufacturer's specification for the duct wrap should be submitted with the Type I hood mechanical permit. Accessibility 1. Not less than an additional 20% of the total valuation of the project should be identified on the response letter to indicate improvements to provide an accessible route to the primary function areas, per IBC sections 3411.7 and 3411.8. 2. Pull side dimension of new doors should be shown on the drawings as 18 inches, per ICC/ANSI A117.1- 2009 figure 402.3.2 (a). 3. At least one of the doors in the pair leading to the patio should be shown on the drawings to have a clear width opening of 32 inches, per IBC section 1008.1.1. 4. Hardware should be shown on the door schedule to operate without tight twisting or grasping requiring use of the wrist, per IBC section 1008.1.9.1. 5. The counter detail should indicate the required height for an accessible sales and service counter, per ICC/ANSI A117.1-2009 section 904.3. 6. Accessible seating should be shown in the dining area, per IBC section 1108.2.9.1. 7. Access to the exterior deck should indicate a detail of the threshold and floor material to provide an accessible route, per IBC section 1108.2.9. 8. Elevations of all new toilet rooms should be shown on the drawings to indicate dimensioned fixture locations, grab bars, clearances, and heights, per IBC A117.1-2009 chapter 6. These comments address building issues only. Revisions or additions may be required by other departments (Utilities, Public Works, or Planning). Code references cited include the 2012 International Building Code (IBC), 2012 International Fire Code (IFC), the 2012 International Mechanical Code (IMC:), the 2012 Uniform Plumbing Code (UPC), the 2012 Washington State Energy Code (WSEC), the 2012 International Property Maintenance Code (IPMC), and the ICC/ANSI A117.1-2009 Accessible and Usable Buildings and Facilities. All codes referenced, as adopted by the City of Everett, should include current revisions by the State of Washington. Please note that federal standards for building accessibility may be more restrictive. Please contact me with any questions at 425-257-8813. You can reach me directly to discuss this letter at mhaley@)everettwa.gov or by phone at 425-257-8813. Sin�erely, J Meg Haley, RA Plan Reviles Architect � l