2216 127TH PL SE 2017-06-07 - Laserfiche WebLink

R311.8 Ramps Inside Ram YES NO R311.8.1 Maximum Slope one unit vertical in twelve units horizontal 8.3%slope). Exception R311.8.1 Not allowed in AFH ❑ ❑ R311.8.2 Landing Requirements:min.3X3 foot landing at top/bottom,where doors open onto ramps,and where ramp ❑ ❑ changes directions. R325.9.1 Handrails required on both sides of ramp in accordance with R311.8.3.1—R311.8.3.3. ❑ ❑ Outside Ramo YES NO R311.8.1 Maximum Slope one unit vertical in twelve units horizontal 8.3%slope). (Exception R311.8.1 Not allowed in AFH)_ ❑ ❑ R311.8.2 Landing Requirements: min. 3X3 foot landing at top/bottom, where doors open onto ramps, and where ramp ❑ ❑ changes directions. R325.9.1 Handrails required on both sides of ramp in accordance with R311.8.3.1—R311.8.3.3. ❑ ❑ *Guards below are depicted vertically as an example only. All Ramps must have Guards Less than 4" Handrail both sides 34"—38" Guard 36"min 3'x3'min 3'x 3'min — — landing landing ~~ 1:12 max slope 3' < 3' 8.3 t min ADULT FAMI-Y HOME RAMP per 2009 IRC with WA. ST. AMENDMENTS *,ALL RAMPS REQUIRE A BUILDING PERMIT* R311.2 Means of Egress YES NO R311.2 Door must be side-hinged with min.width of 32 inches between face of door and stop.Height not less than 78 inches. ❑ R325.4 Operable parts of door handles, pulls,latches,locks and other devices installed in AFH shall be operable with one hand and shall not require tight grasping, pinching or twisting of the wrist(lever-type,emergency egress hardware). The Exit doors �+ ❑ shall have no additional locking devices. R311.7 Stairways N/A YES NO R311.7.4.1 Riser Height: Max riser height shall be 7'/4 inches (8 inches in structures built prior to July 1, 2004) M ❑ R311.7.4.2 Tread Depth: Min.tread depth shall be 10 inches. (9 inches in structures built prior to July 1,2004) ❑ R325.10.1 Handrails for Treads and Risers shall be installed on both sides of treads and risers numbering from one riser to ❑ multiple risers.Handrails shall be installed in accordance with E;311.7.7.1—R311.7.7.4 R 325.8 Grab Bars in Bathrooms(May require"alternate"approval in accordance with IRC Sec. R104.10 and.11YES NO R325.8 Grab bars shall be installed for all water closets(toilets),bathtubs and showers_. Bathing facilities such as tubs and showers;and 19 ❑ On both sides of the toilet. shall comply with ICC/ANSI Al 17.1 Sections 604.5,607.4&608.3 ❑ AGI 03—AG 105 Swimmin Pool Spa, Hot Tub YES NO AG105.2 Must be surrounded by a barrier that is 48 inches high, may have doors and or gates that must have audible ❑ ❑ alarms when opened. AG105.5 EXCEPTION:Pools, Spas or hot tubs with a safety cover which complies with ASTM F 1346 ❑ ❑ ❑ PASSED ❑ CORRECTIONS REQUIRED ❑ PERMIT REQUIRED INSPECTOR'S SIGNATURE: DATE: INSPECTOR'S ADDRESS: PHONE: Application and Inspection Checklist developed by Washington Association of Building Officials (WABO), in cooperation with Department of Social and Health Services (DSHS) for use by both departments and licensors. 08/01110