5631 HIGHWAY PL 2017-07-12 - Laserfiche WebLink

POTTER P200 Plus 4 Fire Alarm Control Panel SLC Features RA-6500-4 x 40 LCD annunciator with a key pad in a locked metal enclosure The Potter/Nohmi protocol is a digital protocol with a proven design for reliability and noise immunity.The system does not require special LED-16—16 LED annunciator with common indicators in a locked cable or conductors for connection of the Signaling Line Circuit as metal enclosure long as the cable is compliant with NFPA 70 and NFPA 72.The system PSN-1000(E)—10 amp,remote intelligent power supply with 6 NACs, allows for Class A or Class 13 installations as well as"T—Taps." 21/Os and a P-Link repeater The total polling time for the protocol is about four(4)seconds which CA-6075—Class A convertor that converts the SLC,NACs and P-Link allows two polling cycles in the ANSI/UL 864 requirement of alarms connection reporting in less than ten seconds.Each loop is capable of 127 points UD-1 U00—UL listed,Dual line telephone alarm communicator with the exception of the P100 and P200. DRV-50—LED driver expander,used to connect up to 50 LEDs in a Sensor Features graphic display The sensors through the fire alarm control panel provide a real FCB-1000—Fire communication bridge,provides remote mounting of time status as to the condition of the system.The smoke detector the Ethernet connection sensitivity,heat detector temperature level and drift compensation FIB-1000—Fiber interface module,used to extend P-Link to multi- as all programmable options.The system also allows for a day/night mode fiber(2 required) mode where the panel automatically adjusts the sensitivity depending on the time of day.To assist in the reduction of false alarms,the smoke RL Y-5—Relay module,provides 5 form C relay contacts rated at 3.0 detectors also have a maintenance warning that sends a trouble signal amps 24VDC/125AC when a detector is dirty to the point that it can no longer maintain the SPG-1000—Serial parallel gateway,allows f'or the connection to a programmed sensitivity. serial or parallel printer User Interface The FIB-1000,FCB-1000 and the SPG-1000 may be installed in the stacker bracket or ordered with the optional rack mount enclosure. The fire alarm control panel has a 2 x 16 LCD display to provide information to the system status.The keypad has navigation keys Ethernet/I.P. Connection to allow manipulation of the Menu on board the panel.The panel is shipped standard with the following LEDs: The Y200 is shipped standard with an Ethernet connection.This connection is the programming port and may be connected to a building • AC Power—Green Wide Area Network(WAN)or Local Area Network(LAN).Once • Alarm—Red connected to the Internet,the panel may be selectively programmed to e-mail alarm conditions,trouble conditions,supervisory conditions,test, • Earth Fault—Amber Event History and detector status.An e-mail may be sent to the panel • Supervisory-Amber and the panel will e-mail the event history,detector status,configuration • Silenced-Amber file or server status to an authorized E-mail account.In addition, reminders may be set to send an e-mail for service,testing or other • Trouble-Amber conditions. The common buttons include a Silence,Reset,Acknowledge and Drill. In addition,the Ethernet connection is UL listed as an IP communicator. All of the buttons are accessible once the locked door is opened. The IP communicator is listed to report to the UL listed Sur-Gard 111 P-Link IP receiver.The 1P communicator replaces the traditional less reliable alarm communicator transmitter that utilized telephone lines.The IP The P200 has a proprietary communication protocol that communicates communicator is an active method of connection and communication to through a RS-485 connection to field devices.Up to thirty-one(3 1) the monitoring station. of each of the following devices may be connected to a single P-Link lines.The I.P.communicator is an active method of connection and connection.The P-Link includes the communication terminals and communication to the monitoring station. regulated 24 VDC connection for the field devices.The field devices may be any of the following: RA-6075—2 x 16 LCD annunciator with a key pad in a locked metal enclosure. Potter Electric Signal Company,LLC • St.Louis,MO ©P()TTM 800-325-3936 • www.pottersignal.com PksJ #8830034-RFV A PAGE 3 OF 4 08/12