4006 HIGH ST 2018-01-18 - Laserfiche WebLink

� � for deck joists, stairs, guardrail (on stairs and at flat deck), handrails, ledger attachment, lateral connections per R507 IRC etc. 5. Provide Washington State Energy Code (WSEC) compliance information including U- value of all windows and doors, insulation value in all components (ceiling, walls, floor, below grade walls). Show insulation required in all new (walls added w/o permits) and existing exterior walls. 6. Specify which option from table R406.2 of the Washington State Energy Code you are using to obtain the required 0.5 credits for energy code compliance. To qualify for energy credit the option chosen and the specific requirements of that option need to be shown on the construction drawings. 7. Define thermal envelope in basement. Show which portion(s) of basement are heated. If thc basement has tf�e capacity to be heated it is required to be insulated to the minimum requirements of the WSEC, provide R-21 insulation in interior walls that separate heated space from unheated spaces. If basement, or a portion of, is unheated, the floor above the unheated spaces is required to be insulated. Show on plans and provide section drawing. 8. Water heater is required to be strapped for seismic loads and installed on non- compressible insulation. Show the requirements on the plans. Provide pressure relief valve to exterior. Show on plans. 9. Provide handrails for all stairs, interior and exterior. Show requirements on the plans. Show handrails in plan views. R311.7.8 IRC 10. Specify which whole house ventilation system will be used to meet the requirements of section M1507.3. Specify the code requirements of the section chosen , do not simply reference the section. 11. Provide 36" landing (measured in the direction of travel) at the top and bottom of all stairs (interior and e�erior). 12. Specify fixture clearances of all bathroom fixtures on plan view. 13. Specify tempered safety glass in required locations as defined by section R308 IRC. Show on plans. 14. Specify how furred walls in basement will be fireblocked. 15. The windows shown on the floor plans do not accurately reflect the location of the windows in the existing structure (including basement door and window). Please correct. 16. Label all spaces for the intended use. i i�'-� i S:\1Common\Clerical\JHeilman\C1507 008 revised 11-ll-20]5(4006 High St).doc