2927 WETMORE AVE 2018-02-12 - Laserfiche WebLink

• • PIERCE DESIGN the 2015 IMC we feel that not installing a Type II hood meets the intent and purpose of the code and does not lessen heath, life and fire safety requirements. 4. The drawings should indicate how the ventilation will occur, per IMC section 403.1, 403.3.1.1 and WSEC C103.2 item 4. Response: Ventilation will occur by a means of natural ventilation(operable windows and doors)per section 401.2 and 402.1 and mechanical ventilation(exhaust fans) per 403.1, 403.3.1.1. Fan locations and minimum ventilation rates are located on Sheet E1.0. Additional ventilation requirements, per design/build system and differed submittal. a) The existing in-line heater shown above the ceiling in the new prep area should be shown to meet the requirements of the WSEC C403. How is the heat transferred through the ceiling to the prep area? Please identify the fuel source for this heater. Response: Fuel source for the existing heaters are natural gas, and noted on detail 1, Sheet A3.0. The heat is not transferred through the ceiling into the prep area, it supplies heating to the main cafe space. Specification cut sheet is included, Reznor model UDAP. Compliance with WSEC C403 Mechanical Systems is deferred until a qualified HVAC technician or engineer has qualified the system and prepared a mechanical permit submittal, although we don't anticipate replacing or altering the existing heaters per C503.4. 5. Please indicate the current mechanical system locations and cfm for the coffee shop and toilet rooms,per IMC Table 403.3.1.1 requirements for Food and Beverage Service and requirements for Public Spaces Public Toilet rooms. Response: Prep area and toilet room fan c.f.m. rates are shown on E.1.0, additional ventilation requirements, per design/build system and differed submittal. 6. A commercial kitchen plumbing permit application is required. Response: A separate commercial plumbing permit will be pulled. Regards, Wesley Pierce Project Designer Pierce Design Please submit your revisions using the following protocol: Please review and respond to the comments below. Plan review will resume when the requested information is submitted. All required submittals must be of sufficient detail and information to ensure that the proposed structures will be constructed in compliance with all adopted codes, with two sets of drawings submitted for revisions.All revisions require the person delivering the drawings to replace revisions into the two review sets here at our offices. For significant revisions,please provide two full replacement sets. If the revisions are coming directly from the blue-printer, please make arrangements with them to print two replacement sets. CORRECTIONS RESPONSE LETTER PAGE 4 of 4 Pierce Design 2300 W Commodore Way Suite 201 Seattle,WA 98199 T 206-792-9396 E-mail wes@wespierce.com