1005 PACIFIC AVE 2019-07-31 - Laserfiche WebLink

Lighting, Motor, and Transformer Permit Documents Checklist LTG-CHK 2012 Washington State Energy Code Compliance Forms for Commercial Buildings including R2&R3 over 3 stones and all R1 Revised Jan 2014 Project Address PSKC Everett Remodel Date 5/20/2016 The following information is necessary to check a permit application for compliance with the lighting,motor,and transformer requirements in the Washington State Energy Code,Commercial Provisions. Applicability Location in Building Department (yes,no,na) Code Section Component Compliance information required in permit documents Documents Notes LIGHTING CONTROLS(Section C405.2) C405.2.1.1 Manual interior Indicate on plans the manual control type&locations served; Yes C405.2.1.2 lighting controls Indicate of plans the 50%lighting load reduction method provided or identify exception taken Indicate lighting system automatic shut-off capability-identify lighting zone areas served on plans; Automatic time Indicate locations of override switches on plans and the areas Yes C405.2.2.1 switch controls and served,include area sq.ft.; override switching Indicate locations where automatic shutoff is provided by other methods(occupancy sensor,daylight controls,etc) Yea C405.2.2.2 Occupancy sensors Indicate on plans the locations served by occupancy sensors Daylight zones- Indicate vertical fenestration primary and secondary daylight Yes C405.2.2.3 Vertical fenestration zone areas on plans,include sq.ft.; and skylights Indicate skylight daylight zone areas on plans,include sq.ft. Daylight zone Indicate on plans the locations served by daylight zone controls; Yes C405.2.2.3.2 controls Indicate in plans the lighting load reduction(dimming)method- stepped or continuous dimming Specific application Indicate on plans the locations served by specific application NA C405.2.3 lighting controls- lighting controls General Indicate lighting control method for display and accent lighting, C405.2.3- Display and accent and display case lighting; NA Indicate these fixtures are controlled independently from both Items 1&2 lighting general area lighting and other lighting applications within the same space C405.2.3- Hotel/motel guest Provide a lighting control device at each guest room entry for all NA permanently installed fixtures in guest room; Item 3 rooms Indicated whether lighting control is manual or automatic Yes C405.2.3- Supplemental task Provide automatic shut-off vacancy controls for supplemental Item 4 lighting task lighting,including under-shelf or under-cabinet lighting Identify eligible non-visual applications and method of lighting C405.2.3- Lighting for non- control; NA Indicate these fixtures are controlled independently from both Item 5 visual applications general area lighting and other lighting applications within the same space Indicate lighting control method for lighting equipment for sale C405.2.3- Lighting equipment or demonstration; NA for sale or Indicate these fixtures are controlled independently from both Item 6 demonstration general area lighting and other lighting applications within the same space If egress lighting power density is greater than 0.05W/ft2, C405.2.3- Means of egress indicate method of automatic shut-off during unoccupied Yes Item 7 lighting periods; Identify on plans the egress fixtures that function as both normal and emergency means of egress illumination C405.10 Cooler and freezer Provide vacancy device or timer to turn off fixtures within 15 NA C405.11 lighting minutes of unoccupancy for cooler and freezer lighting fixtures with lamp efficacy less than 40 lumens per watt Yes C405.2.4 Exterior lighting Indicate on exterior lighting plans the automatic lighting control controls method and locations served Exterior building Provide motion sensor controls for building grounds fixtures Yes C405.6.1 grounds lighting rated at greater than 100 watts with lamp efficacy less than 60 controls lumens,or identify exception taken Identify applicable commissioning documentation requirements per Section C408 or eligibility for exception; Yes C408.3 Lighting system Provide written procedures for functional testing of all automatic functional testing controls and describe the expected system response; Identify in construction documents the party responsible for functional testing of automatic lighting controls INTERIOR LIGHTING POWER & EFFICACY(Sections C405.5, C405.10, C405.11) Provide fixture schedule with fixture types,lamps,ballasts,and �<< rated watts per fixture;