Laserfiche WebLink
Exterior Lighting LTG-EXT""" <br /> 2015 Washington State Energy Code Compliance Forms for Commercial Buildings including R2,R3,R4 over 3 stories and all R1 Revised August 2016 <br /> Project Title: CHC EVERETT-CENTRAL MEDICAL&ADMIN.FACILITY Date 5/5/2017 <br /> Exterior Lighting For Building Department Use <br /> o Zone 1 Q Zone 2 0 Zone 3 Q Zone 4 <br /> Zone Table C405.5.2(1) <br /> Specified by jurisdiction. Zone selection required to enable LTG-EXT form <br /> Calculation Area Q O Addition- O Addition <br /> stand alone +existing <br /> O Alteration with<50% O Alteration with>_50%ext. <br /> ext.wattage replaced wattage replaced <br /> Building Grounds Q Efficacy>80 lumens/watt [11 Exemption <br /> Applies to luminaires> <br /> 100 Watts ❑Controlled by motion sensor <br /> Tradable Maximum Allowed Lighting Wattage NOT' <br /> Base Site Allowance: 1300 <br /> Area(ft`),perimeter(If) Allowed Watts Allowed Watts <br /> Tradable Surfaces Surface Description or#of items per ft2 or per If x ft2(or x It) <br /> Uncovered Parking and drives Main and Accessory Parking Area(Excludes 33338 0.10 W/ft2 3334 <br /> building area-no changes) <br /> Total Allowed Tradable+Site Allowance Watts: 4634 <br /> Tradable Proposed Lighting Wattage"OTE 2 <br /> Number of Watts per Watts <br /> Tradable Surface Fixture Description NOTE 3,4 Fixtures Fixture NOTE 5 Proposed <br /> Uncovered Parking and drives 2-head LED fixture @ 511 watts per fixture(LED 10 511 5110 <br /> lamps in array) <br /> Total proposed tradable watts may not exceed the sum of total allowed tradable Total Proposed Tradable Watts: 5110 <br /> watts plus the base site allowance. Any base site allowance not needed to make <br /> tradable watts comply can be applied to individual non-tradable categories. <br /> Non-Tradable Maximum Allowed Lighting Wattage"1'1 Site Allowance Remaining: 824 <br /> Area(ft2),perimeter(If) Allowed Watts Allowed Watts <br /> Non-Tradable Surfaces Surface Description or#of items per ft2 or per If x ft2(or x If) <br /> Non-Tradable Proposed Lighting Wattage"OTE 2 <br /> Number of Watts per Watts <br /> Non-Tradable Surface Fixture Description NOTE 3,4 Fixtures Fixture NOTE 5 Proposed <br /> Non-tradable proposed watts may not exceed allowed watts for any individual Non-Tradable Watts Exceeding LPA: 0 <br /> surface unless the total excess watts for all non-tradable surfaces are less than the <br /> remaining site allowance. Remaining Site Allowance: 824 <br /> Exterior Lighting COMPLIES WITH MAX. ALLOWANCE! <br /> Note 1-List all unique exterior sufaces per Table C405.5.2(2)that occur in the project scope::Select exterior surface categories from drop <br /> down menu. <br /> Note 2-List all proposed lighting fixtures including existing-to-remain fixtures. <br /> Note 3-For proposed Fixture Description,indicate fixture type,lamp type,number of lamps in the fixture,and ballast type(if applicable). <br /> Note 4-Existing-to-remain fixtures shall be included in the Tradable and Non-Tradable Proposed Lighting Wattage tables in the same manner <br /> as new fixtures.Identify as existing in fixture description. <br /> Note 5-For proposed Watts/Fixture enter the luminaire wattage for installed lamp and ballast using Manufactureror other approved source.For .. <br /> luminaires with screw-in lamps,enter the manufacturer's listed maximum input wattage ofithelixturelnot,the lamp wattage).For low ,,r( c>f, <br /> voltage lighting,enter the wattage of the transformer. • i', t rq, von ' <br />