5901 23RD DR W BRIDGEWAYS 2018-04-16

/ Interior Lighting Sunk.riary LTG-SUM 2012 Washington State Energy Code Compliance Forms for Commercial Buildings including R2&R3 over 3 stories and all R1 Revised Jan 2014 Project Info Project Address Bridgeways Date 9/22/2015 Compliance Soundview Center Buiding A For Building Department Use forms do not require a Everett,WA password to Applicant Name: use. Instructional Lance Mueller Architects and calculating Applicant Address: 130 Lakeside,Suite 250 cells are write- protected. Applicant Phone: 206-325-2553 Project Description ❑ New Building 0 Addition ID Alteration 0 Plans Included Lighting Power Density Calculations 0 Total Building Performance Lighting Compliance Path o (If Total Building Performance then only LGT-CHK is required.) Lighting Power Allowance O Building Area Method OQ Space-By-Space Method Method Selection required to enable LPA forms Interior Lighting System New flourescent and incandescent lighting within existing building. Tenant space has not Description been occupied before. New ceiling and light fixtures will be provided per this permit. All lighting controls,occupancy sensors and commisioning will be by electrical contractor. Briefly describe lighting system type and features. Additions and Change of Space Use (C101.4.3 &C101.4.4) ❑ Addition area or Change of Space Use area complies with all applicable provisions as stand alone project ❑ Addition area is combined with existing building lighting systems to demonstrate compliance with all applicable provisions per C101.4.3 Provide Building Area Method(LTG-INT-BLD)or Space-By-Space Method(LTG-INT-SPACE)Compliance Form.Document maximum allowed and proposed(including existing if applicable)lighting wattage of Addition or Change of Use space.Provide applicable lighting controls per C405.2 and commissioning of lighting controls per C405.13. Alterations,Renovations and Repairs (C101.4.3.1) ❑ 60%or more of luminaires in space replaced Provide Building Area Method(LTG-INT-BLD)or Space-By-Space Method(LTG-INT-SPACE)Compliance Form.Document maximum allowed wattage within the lighting retrofit space in Maximum Allowed Wattage table and proposed(including existing)lighting wattage in Proposed Wattage table.Retrofit and non-retrofit spaces shall be documented separately using multiple forms. ❑ Less than 60%of luminaires in space replaced Provide a separate Space-By-Space Method(LTG-INT-SPACE)Compliance Form for this retrofit area.Document existing total wattage within the lighting retrofit space in cell provided in the Maximum Allowed Wattage table.Document proposed(including existing)lighting wattage in the Proposed Wattage table. ❑ Lamp and/or ballast replacement within existing luminaires only—existing total interior building wattage not increased O New wiring installed to serve added fixtures and/or fixtures relocated to new circuit Provide applicable manual lighting controls(C405.2.1),occupancy sensors(C405.2.2.2),daylight zone controls(C405.2.2.3),specific application controls(C405.2.3),and commissioning of lighting controls per C405.13 ❑ New or moved lighting panel Provide all applicable lighting controls as noted for New Wiring,automatic time switch controls(C405.2.2.1),and commissioning of lighting controls per C405.13. ❑ Space is reconfigured-luminaires unchanged or moved only Provide all applicable lighting controls as noted for New Wiring and commissioning of lighting controls per C405.13. O No changes are being made to the interior lighting and space use not changed.