6000 23RD DR W TEAGUE 2018-04-16

PUBLIC WORKS E-----Sent vii e-mail 7 August 14, 2015 Mr. Chien Chen Collins Woerman 710 Second Ave, Ste. 1400 Seattle, WA 98104 Project: TI FOR OFFICES ONLY (PHASE I) -TEAGUE Owner and Tenant: NICHOLSON MACHINE &TECHNOLOGY and TEAGUE Job Address: 6000 23RD DR W Permit: B1507-053 RE: CORRECTIONS LETTER Dear Mr. Chen, In response to the application for permit, the plans have been examined and you are advised that revisions are necessary before a permit can be issued. Please submit a response letter indicating where each item in the corrections letter is addressed on the drawings, with two printed sets of drawing revisions (slip-sheeted at the counter by the applicant). Plan review will resume when the requested information is submitted. All required submittals must be of sufficient detail and information to ensure that the proposed structures will be constructed in compliance with all adopted codes, Geral 1. Please include the construction type in the code analysis. The original permit for the building was for construction type VB. 2. The original area of the building was 60,000 square feet. The area under this permit is indicated as 63,000 square feet. There have not been permits submitted to increase the floor area. Please clarify. 3. The occupancy is indicated as F-1 under this permit, where it was originally permitted as F-2. Please clarify the change of use in the code analysis, and identify the F-1 tenant area as a deferred permit application. 4. The site plan (sheet A1.1.C) indicates Pacific Coast Marine but the permit application is for a new tenant. The site plan submitted under this permit is being reviewed as part of this permit application. If the intention is to defer the site plan, please include it in the deferred permit submittal. 5. Please identify all new work or deferred permit work on the drawings. a. For example, if parking lot lines are being restriped, that extent of that work should be identified on the drawings *(all new striping should be dimensioned, curb cuts should be detailed, and the accessible parking sign design, location, and height should be shown on the drawings). b. The factory/warehouse revisions should be referenced as a deferred permit. Construction `/ 1. New parking spaces and driving aisles should be dimensioned relative to the property line locations. ✓ 2. Parking should be dimensioned in width and depth to meet Everett Design and Construction Standards.