6000 23RD DR W TEAGUE 2018-04-16

3. The accessible parking space and curb cut should be shown on the drawings and dimensioned relative to the accessible building entrance. ./4. Contour lines, sidewalk widths, doors and ramps should be shown on the drawings and detailed, along the accessible route to the main entrance from the new accessible parking area. 5. New walls should be targeted to wall sections, indicating the height of the wall and the relationship to ceiling and underside of structure. 6. Please indicate exit signage and emergency illumination on the reflected ceiling plans, per IBC sections 1006.3 and 1011.1. 7. Braille exit signage should be indicated on the plans per IBC section 1011.4. 8. Pull side dimension of new door (112) should be shown on the drawings as 18 inches, per ICC/ANSI A117.1-2009 figure 402.3.2 (a). 9. Hardware should be shown on the door schedule to operate without tight twisting or grasping requiring use of the wrist, per IBC section 1008.1.9.1. 10. Door lites should be shown on the drawings to comply with the heights listed in ICC/ANSI A117.1-2009 section 404.2.10. Accessibility 1. IBC sections 1106.1 and 1106.5 require a van accessible parking space where 1 to 25 parking spaces are provided. a. A facility that is altered should comply with applicable sections of requirements for new construction, unless technically infeasible, per IBC section 3411.6. The parking lot striping is being altered. b. Where an alteration affects the accessibility to a primary function, the route to the primary function area should be accessible, per IBC section 3411.7. i. The cost of providing the accessible route is not required to exceed 20 percent of the costs of the alterations affecting the area of primary function. c. The van accessible space is required to be a total of sixteen feet, with an access aisle of either 5 or 8 feet, per ICC/A117.1-2003 section 502.2. d. Please note that the words ADA on the parking spaces reference a law, but not a requirement of the building code. 2. Parking signage should be shown on the drawings to comply with IBC section 1110.1 and ICC A117.1- 2003 section 502.7. The minimum height to the underside of the sign is 5'-0"above adjacent grade. Upon resubmittal of the drawings, your application will be given priority and plan review will recommence. Applicable codes include the 2012 International Building Code (IBC) and the 2012 International Fire Code (IFC), as amended by the State of Washington and adopted by the City of Everett. Revisions or additions may be required by other departments (such as Utilities, Planning, or Fire). Please contact me if you would like to discuss this letter b e m..1 at mhaley@ everettwa.gov or by phone at 425-257-8813. Sincerely, 14 Meg Haley, RA, 'la R-v' rchitec