3003 W CASINO RD BLDG 40-23 2018-09-21

STATUS LED 4. Refer to publications P/N 06-236120-001 or An LED is provided on the SmartOne to indicate status of P/N 06-236121-001 for recommended field wiring. the smoke detector. A high flash rate indicates alarm, a Note: Nominal factory settings of detectors are as fol- slow rate normal. When a trouble exists, the LED is lows: turned off. PROGRAMMING INFORMATION Photoelectric detectors: Alarm 2.0%/ft. Each detector is field programmed with the owner loca- Pre-alarm 1.5%/ft. tion message (location of the detector in the building or lonization detectors: Alarm 1.0%/ft. on the site), the system address (a four digit code), pre- Pre-alarm 0.8%/ft. alarm set point and alarm set point (if different from fac- Thermal detectors: Alarm 140°F (60°C) tory settings). In addition, the detector type, either photo- Pre-alarm 120°F(49°C) electric, ionization or thermal and the proper calibration are stored in memory at the factory. This permits the The system will reject attempts to program alarm and Central Control Panel to verify that the proper detector pre-alarm set point levels exceeding the UL designated type using the correct address is installed in the system. W�ndow. BASE WIRING INFORMATION ALARM TEST BY COMMAND Any or all detectors can be tested by command from the O U O � O Q Central Control Panel. This test procedure precisely duplicates in-place testing of each detector by imposing a signal on the detector sensing chamber that will cause an 7 3 7 3 alarm output. Results of the test will be indicated at the Central Control Panel or any remote location for monitor- O O � U ing or troubieshooting purposes. � � COMMUNICATION VERIFICATION To wdTx When a detector reaches its pre-alarm or alarm set point, it conducts a verification procedure with the Central Con- trol Panel which repeats the communication cycle four separate times before the system accepts its change of To prevent detection contamination status. The maximum time for this verification procedure Aand subsequent warranty cancellation, is 2.5 seconds. CAUTION smoke detectors must remain covered DETECTOR IDENTIFICATION until area is clean and dust free. GENERAL NOTES Part Number Description 1. No E.O.L. device is needed for SmartOne detectors. 70-400001-100 Common 6-in. Base 2. T"tapping wiring method is acceptable for Class"B" Model 6S6 wiring. The number of taps used is a function of good practice. 70-40001-101 Common 4-in. Base 3. To ensure proper installation of the detector head to Mode14SB the base, be sure wires are properly dressed at 70-40001-200 Mechanical Adapter installation. Model MA-002 a. Position all wires flat against the base. b. Take up all slack in outlet box. 70-402001-100 lonization Detector c. Route wires away from the connector termi- Model CPD 7052 nals. 71-402001-100 Photoelectric Detector Model PSD 7152 70-404001-100 Thermistor Heat Detector Model THD 7252 -2-