Laserfiche WebLink
_Lay all flagpole components out..lf.missing a part from the attached p���' <br /> diagram, please call 1-888-735-�1 for the replacement parts. <br /> � � <br /> STEP 1 - Remove all wrapping materials and ptace unwrapped pole on <br /> cribbing or other woad support on ground (preferably in a covered dry <br /> area). If Pole is Multi Section, carefully lay sections out in proper order, <br /> grouping poles with like match marks. Sections MUST BE STRAIGHT & <br /> LEVELwhile sliding together. Line up match mark numbers, imprinted at <br /> each section, for proper fit. Lightly sand away any burrs that may be <br /> present on the male section or in the upper section of the joint. A small <br /> amount of lubrication (silicone or dish washing liquid - by others) may be <br /> applied to the male portion of the joint for easier fitting. Start with the <br /> bottom sections and work toward the top. Begin sliding the two sections, <br /> rolling the pole by 180° with every 2 to 3 inches to facilitate an easier fit. <br /> (If EXTREME difficulty is found in fitting the first 6 inches together, pull <br /> back apart and cool the male section with ice for several minutes). A <br /> sledgehammer and block of wood (to protect the pole from direct impact) <br /> may be necessary on larger poles to complete the assembly of joints. <br /> Flagpo(es Etc. suggests the use of an epoxy adhesive for aluminum with <br /> poles of 60' length. <br /> 5TEP 2 - Identify parts and place them along the pole according to the <br /> parts diagram. <br /> STEP 3 - Open truck (part A) by removing screws. Feed taped cable end <br /> of cable assembly (part B) up through bronze fitting in truck housing, up <br /> over the pulley inside the truck's hood, and back down through the <br /> threaded spindle of the truck assembly. Pull a few feet of cable through <br /> truck and re-assemble truck (VERIFY HOOD IS REPLACED SUCH THAT <br /> INSIDE PULLEY IS DIRECTLY OVER CABLE ENTRANCE). Feed cable <br /> down through the pole (may require fish tape) until you can pull it out <br /> through winch door near base of pole. Coil cable and secure to outside of <br /> pole with tape for now. <br /> STEP 4 -With cable fed down through pole, slide sling over top of pole <br /> and carefully screw the threaded stem of the revolving truck (part B) to the <br /> top end of the flagpole, being careful not to pinch or jam cable in threaded <br /> 1:'f� <br />