Laserfiche WebLink
,area (use of thread-ease type prr�i��ct is recommended on this conne�l' i <br /> in order to tighten completely). Tiy���en truck with pipe wrench until tig�t. <br /> _ .Once truck is fastened it should revolve freely. <br /> STEP 5 - Before standing flagpole, slide the flash collar (part H) up from <br /> bottom and secure at the location of the access door with tape on the <br /> underside of flash collar to prevent slipping. Coil up excess cable if <br /> necessary and either stuff inside pole or tape to pole just outside winch <br /> hole while erecting pole. The winch and lock may be installed now or after <br /> erection. <br /> STEP 6 - Determine the style of winch you received. The "small" winch <br /> will have a handle that passes into the winch to allow cranking. The <br /> "large" winch will have a handle that connects to a machined bolt on the <br /> side of the winch for cranking. If you have the "large" winch, instructions <br /> are included in the plastic bag with the bolts and nuts for cable <br /> attachment. If you have the "small" winch (lubrication not required), the <br /> cable attachment should be completed as follows: 1) Loosen the screw on <br /> the drum of the winch, 2) Sit the stop sleeve into the hole below the screw <br /> with cable lying into the grooves on either side, 3) Tighten screw onto stop <br /> sleeve securely. Fasten winch onto plate with pre-drilled holes inside <br /> access door and fasten with screws <br /> provided. Once installed, handle should extend into side of pole and <br /> proceed through or fit over winch. Using the directions shown on the <br /> handle of the winch, you will want to pull the excess cable onto the winch, <br /> keeping tension in cable at all times. The winch allows the flag to fly in <br /> any position on the pole and can be lowered by cranking the handle in the <br /> opposite direction. Snaphook assemblies can be loosened to adjust for <br /> size of flag to be flown. <br /> STEP 7 - Stand flagpole into previously installed ground sleeve. (May <br /> require crane or backhoe for larger flagpoles. Always choke multiple <br /> section poies below lowest joint as a safety precaution). cau�aon:w�en <br /> installing, the pole should be assembled as close as possible to the final support <br /> point. Professionals experienced in such installations should perform rigging and <br /> lifting. During lift keep clear of area and reach of pole path. Do not pass pole <br /> overhead. When instatling multi-piece flagpotes, arrange the rigging for the lift in <br /> / r ( _ �, <br /> �� <br />