6201 ASSOCIATED BLVD BASE FILE 2018-05-29

1.4.2 Deviations/Changes The manufacturer may recommend material alternatives and design changes.The manufacture must recommend these changes in writing prior to production.The manufacturer must not deviate or change items without written approval from the buyer. If items are altered or changed without approval the container parts becomes the manufacture responsibility and will be rejected by the buyer. 1.4.3 Third Party's Code and Practice Sea Box, Inc./JJAP will provide production supervision and QA/QC monitoring. The buyer will appoint a third-party surveyor. 1.4.4 Approval and Certificates Manufacturer will provide the following data: • Third party approval certificate. • Production certificates of series containers by the manufacturers Quality Assurance Department. • Mill certificates for all steel used in the manufacture. • Manufacturer's Quality Seal on each individual container. • Certificate of timber component treatment to the requirement of Australian Commonwealth, Department of Health. 2.0 Dimensions and Ratings 2.1 Dimensions 2.1.1 Finished Assembly External Length 4,876 mm +0/-6 mm (16 ft. +0/-1/4 in.) Width 2,300 mm +0/-5 mm (7 ft. 6 35/64 in. +0/-3/16 in.) Height 2,438 mm +0/-5 mm (8 ft. +0/-3/16 in.) Internal Length 4,723 mm +0/-12 mm (15 ft. 5-15/16 in. +0/-15/32 in.) Width 2,174 mm +0/-10 mm (7 ft. 1-19/32 in. +0/-25/64 in.) Height 2,438 mm +0/-10 mm (8 ft. +0/-25/64 in.) Door Opening Width 2,000 mm +0/-5 mm (6 ft. 6-47/64 in. +0/-3/16 in.) Height 2,000 mm +0/-5 mm (6 ft. 6-47/64 in. +0/-3/16 in.) Cubic Capacity 23.1 cubic meters (816 cubic feet) Squareness Maximum allowable differences between two diagonals on any one of the following surface will as follows : Roof, Bottom and Side Diagonals 1/2" (13mm) Front and Rear Diagonals 3/8" (10mm) pods containers seismic and combustibles.docx Page 9 of 19