615 80TH ST SW 2022-01-03 - Laserfiche WebLink

Project Title: pocock racing shells Date 3/25/2017 Exterior Lighting Zone Table C405.5.2(1) Specified by jurisdiction. O Zone 1 ® Zone 2 O Zone 3 Ozone 4 Zone selection required to enable LTG-EXT form For Building Department Use Calculation Area 0 p Addition - O Addition stand alone + existing o Alteration with < 50% ext. O Alteration with a 50% ext. wattage replaced wattage replaced Building Grounds Applies to luminaires > 100 Watts ❑ Efficacy > 80 lumens/watt ❑ Exemptio ❑ Controlled by motion sensor Tradable Maximum Allowed Lighting Wattage NOTE' Base Site Allowance: 600 Tradable Surfaces Surface Description Area ( ), perimeter (If) or # of items AlloweO Watts per fe or per If Allowed Watts x fe (or x If) Other Entry Door 42 20W/LF door 840 Total Allowed Tradable + Site Allowance Watts: 1440 Tradable Proposed Lighting Wattage "oTE s Tradable Surface Fixture Description NOTE 3, 4 Number of Fixtures Wafts per Fixture NOTE 5 Watts Proposed Other Entry Door LED waiipack, dark sky rated 5 72 360 Total proposed tradable watts may not exceed the sum of total allowed tradable Total Proposed Tradable Watts: n"- n1— 6" Ann.. n14. n)f..,..n..w.. An,. Agin ciin flllnu,flnnC nn+ nnnAAA in Mn1,0 360 tradable watts comply can be applied to individual non -tradable categories. Non -Tradable Maximum Allowed Lighting Wattage "oTE' Site Allowance Remaining: 600 Non -Tradable Surfaces Surface Description Area. (ft), perimeter (If) or # of items Allowed Watts per fe or per If Allowed Watts x ft2 (or x If) Non -Tradable Proposed Lighting Wattage "ore z Non -Tradable Surface Fixture Description NOTE 3,4 Number of Fixtures Watts per Fixture NOTE 5 Watts Proposed Non -tradable proposed watts may not exceed allowed watts for any individual Non Tradable Watts Exceeding LPA: 0 surface unless the total excess watts for all non -tradable surfaces are less than the Remaining Site Allowance: 600 remaining site allowance. Exterior Lighting COMPLIES WITH MAX. ALLOWANCE Note 1- List all unique exterior sufaces per Table C405.5.2(2) that occur in the project scope. Select exterior surface categories from drop down menu. Note 2 - List all proposed lighting fixtures including existing -to -remain fixtures. Note 3 - For proposed Fixture Description, indicate fixture type, lamp We, number of lamps in the fixture, and ballast type (if applicable). Note 4 = Existing -to -remain fixtures shall be included in the Tradable and Non -Tradable Proposed Lighting Wattage tables in the same manner as new fixtures. Identify as existing in fixture description. Note 5 - For proposed Watts/Fixture enter the luminaire wattage for installed lamp and ballast using manufacturer or other approved source. For luminaires with screw -in lamps, enter the manufacturer's listed maximum input wattage of the fixture (not the lamp wattage). For low voltage lighting, enter the wattage of the transformer.