Laserfiche WebLink
. � ( <br />6. Tactile exit signs should be shown on the drawings, per IBC section <br />1011.3. <br />Accessibility <br />1. The van accessible parking space(s) requires the following revision to <br />sh�et A1.1: <br />. Signage: 60 inches above the floor of the parking space, <br />measured to the bottom of the sign, per ICC/ANSI A117.1-2003 <br />section 502.7. <br />2. ��urb ramps should be shown on site plan Al.l to comp!y with the <br />landing requirements and slope requirements of ICC/ANSI A117.1- <br />2003 section 406. Reference Everett Design and Construction <br />Standard drawing 3? OA. <br />3. The width o� the accessible space adjacent to the new ramp should be <br />dimensioned as minimum 8 feet, per ICC/ANSI A117.1-2003 secti�n <br />406. <br />4. Please identify and show the accessible route on the drawings for the <br />three accessible parking spaces located near the emergency generator <br />to the entry doors 100A and 167A, per ICC/ANSI A117.1-2003 section <br />402. <br />5. Vestibules 131.1, 167 and 168 should be dimensioned on the drawings <br />to indicate a clear space of 48 inches between doors in the open <br />position, per ICC/ANSI A117.1-2003 section 4G4.2.5. <br />6. The pull side dimension on door 138A should be shown as minimum 18 <br />inches, and the landing should be dimensioned as five feet deep on the <br />drawings, per ICC/ANSI A117.1-2003 sectiori 404.2.3.1 (a). <br />7. The approach to the latch side of the toilet compartment door should <br />be shown as minimum 42 inch minimum width on the drawings, per <br />ICC/ANSI A117.1-2003 section b04.8.3. <br />8. The flush control on the water closet should be shown on the wide side <br />of the accessible stall, per ICC/ANSI A117.1-2003 section 604.6. <br />9. The length of the side horizontal grab bar in the accessible toilet stall <br />should be shown as minimum 42 inches on the drawings, per <br />ICC/ANSI A117.1-2003 section 604.5.1. <br />10. The drawings should indicate a note for insulation required at the <br />water supply and drain pipes under the lavatories, per ICC/ANSI <br />A117.1-2003 section 6C6.6. <br />