McCann Construction Enterprises Inc 11/7/2018

I • 1 No payment will be made for the rejected materials or the removal of the materials 2 unless the Contractor requests that the rejected material be tested. If the Contractor 3 elects to have the rejected material tested, a minimum of three representative samples 4 will be obtained and tested. Acceptance of rejected material will be based on 5 conformance with the nonstatistical acceptance Specification. If the CPF for the rejected 6 material is less than 0.75, no payment will be made for the rejected material; in addition, I 7 the cost of sampling and testing shall be borne by the Contractor. If the CPF is greater 8 than or equal to 0.75, the cost of sampling and testing will be borne by the Contracting 9 Agency. If the material is rejected before placement and the CPF is greater than or equal 10 to 0.75, compensation for the rejected material will be at a CPF of 0.75. If rejection 11 occurs after placement and the CPF is greater than or equal to 0.75, compensation for 12 the rejected material will be at the calculated CPF with an addition of 25 percent of the 13 unit Contract price added for the cost of removal and disposal. 14 15 5-04.3(11)D Rejection - A Partial Sublot 16 In addition to the random acceptance sampling and testing, the Engineer may also 17 isolate from a normal sublot any material that is suspected of being defective in relative 18 density, gradation or asphalt binder content. Such isolated material will not include an 19 original sample location. A minimum of three random samples of the suspect material 20 will be obtained and tested. The material will then be statistically evaluated as an 21 independent lot in accordance with Section 1-06.2(2). I 22 23 5-04.3(11)E Rejection - An Entire Sublot 24 An entire sublot that is suspected of being defective may be rejected. When a sublot is 25 rejected a minimum of two additional random samples from this sublot will be obtained. 26 These additional samples and the original sublot will be evaluated as an independent lot 27 in accordance with Section 1-06.2(2). I28 29 5-04.3(11)F Rejection -A Lot in Progress 30 The Contractor shall shut down operations and shall not resume HMA placement until 31 such time as the Engineer is satisfied that material conforming to the Specifications can 32 be produced: I 33 34 1. When the Composite Pay Factor (CPF) of a lot in progress drops below 1.00 and 35 the Contractor is taking no corrective action, or 36 2. When the Pay Factor (PF) for any constituent of a lot in progress drops below 37 0.95 and the Contractor is taking no corrective action, or 38 3. When either the PFi for any constituent or the CPF of a lot in progress is less 39 than 0.75. 40 41 5-04.3(11)G Rejection - An Entire Lot (Mixture or Compaction) 42 An entire lot with a CPF of less than 0.75 will be rejected. 43 44 5-04.3(12) Joints 45 46 5-04.3(12)A HMA Joints I I N. BROADWAY TRANSIT IMPROVEMENT PROJECT STATE FUND#GCB2316; COE WO#3644 91 August 8, 2018