KLB Construction Inc 11/20/2018 - Laserfiche WebLink

I 1 2 8-01.3(16) Removal I 3 This section is revised to read: 4 5 The Contractor shall remove all temporary BMPs, all associated hardware and I 6 associated accumulated sediment deposition from the project limits prior to Physical 7 Completion unless otherwise allowed by the Engineer. When the temporary BMP 8 materials are made of natural plant fibers unaltered by synthetic materials the Engineer I 9 may allow leaving the BMP in place. 10 11 The Contractor shall remove BMPs and associated hardware in a way that minimizes I 12 13 soil disturbance. The Contractor shall permanently stabilize all bare and disturbed soil after removal of BMPs. If the installation and use of the erosion control BMPs have 14 compacted or otherwise rendered the soil inhospitable to plant growth, such as I 15 construction entrances, the Contractor shall take measures to rehabilitate the soil to 16 facilitate plant growth. This may include, but is not limited to, ripping the soil, 17 incorporating soil amendments, or seeding with the specified seed. 18 I 19 At the request of the Contractor and at the sole discretion of the Engineer the CSWGP 20 may be transferred back to the Contracting Agency. Approval of the Transfer of 21 Coverage request will require the following: I 22 23 1. All other Work required for Contract Completion has been completed. 24 I 25 26 2. All Work required for compliance with the CSWGP has been completed to the maximum extent possible. This includes removal of BMPs that are no longer 27 needed and the site has undergone all Stabilization identified for meeting the 28 requirements of Final Stabilization in the CSWGP. 29 30 3. An Equitable Adjustment change order for the cost of Work that has not been I 31 completed by the Contractor. 32 33 4. Submittal of the Washington State Department of Ecology Transfer of 34 Coverage form (Ecology form ECY 020-87a) to the Engineer. I 35 36 If the Engineer approves the transfer of coverage back to the Contracting Agency, the 37 requirement in Section 1-07.5(3)for the Contractor's submittal of the Notice of I 38 Termination form to the Washington State Department of Ecology will not apply. 39 40 8-01.4 Measurement I 41 This section's content is deleted and replaced with the following new subsections: 42 43 8-01.4(1) Lump Sum Bid for Project (No Unit Items) I 44 When the Bid Proposal contains the item "Erosion Control and Water Pollution 45 Prevention" there will be no measurement of unit or force account items for Work 46 defined in Section 8-01 except as described in Sections 8-01.4(3) and 8-01.4(4). Also, I 47 48 except as described in Section 8-01.4(3), all of Sections 8-01.4(2) and 8-01.5(2) are deleted. 49 I IWEST MARINE VIEW DRIVE UTILITIES PAGE 36 OF 60 August 2018 WORK ORDER#3588 I WSDOT AMENDMENTS Rev 4/2/18