Laserfiche WebLink
1 EquipmentDrawings 8-20.2(1) List and <br /> 2 <br /> 3 8-20.3(4) Foundations <br /> 4 The second sentence of the first paragraph is revised to read: <br /> 5 <br /> 6 Concrete for Type II, Ill, IV, V, and CCTV signal standards and light standard <br /> 7 foundations shall be Class 4000P and does not require air entrainment. <br /> 8 <br /> 9 8-20.3(5)A General <br /> 10 The last two sentences of the last paragraph is deleted. <br /> 11 <br /> ' 12 This section is supplemented with the following: <br /> 13 <br /> 14 All conduits shall include a pull tape with the equipment grounding conductor. The pull <br /> 15 tape shall be attached to the conduit near the end bell or grounded end bushing, or to <br /> 16 duct plugs or caps if present, at both ends of the conduit. <br /> 17 <br /> 18 8-20.3(8) Wiring <br /> 19 The seventeenth paragraph is supplemented with the following: <br /> 20 <br /> 21 Pulling tape shall meet the requirements of Section 9-29.1(10). Pull string may not be <br /> 22 used. <br /> 23 <br /> 24 8-21.AP8 <br /> 25 Section 8-21, Permanent Signing <br /> 26 January 2, 2018 <br /> ' 27 8-21.3(9)F Foundations <br /> 28 Item number 3 of the twelfth paragraph is supplemented with the following new sentence: <br /> 29 <br /> ' 30 Class 4000P concrete for roadside sign structures does not require air entrainment. <br /> 31 <br /> 32 9-02.AP9 <br /> ' 33 Section 9-02, Bituminous Materials <br /> 34 April 2, 2018 <br /> 35 9-02.1 Asphalt Material, General <br /> 36 The second paragraph is revised to read: <br /> 37 <br /> ' 38 <br /> 39 The Asphalt Supplier of Performance Graded (PG) asphalt binder and emulsified <br /> asphalt shall have a Quality Control Plan (QCP) in accordance with WSDOT QC 2 <br /> 40 "Standard Practice for Asphalt Suppliers That Certify Performance Graded and <br /> 41 Emulsified Asphalts". The Asphalt Supplier's QCP shall be submitted and receive the <br /> 42 acceptance of the WSDOT State Materials Laboratory. Once accepted, any change to <br /> 43 the QCP will require a new QCP to be submitted for acceptance. The Asphalt Supplier <br /> 44 of PG asphalt binder and emulsified asphalt shall certify through the Bill of Lading that <br /> 45 the PG asphalt binder or emulsified asphalt meets the Specification requirements of the <br /> 46 Contract. <br /> 47 <br /> ' 48 9-02.1(4) Performance Graded Asphalt Binder (PGAB) <br /> 49 This section's title is revised to read: <br /> WEST MARINE VIEW DRIVE UTILITIES PAGE 44 OF 60 August 2018 <br /> WORK ORDER#3588 <br /> WSDOT AMENDMENTS Rev 4/2/18 <br />