Laserfiche WebLink
• <br /> Exterior Lighting LTG-EXT <br /> 2015 Washington State Energy Code Compliance Forms for Commercial Buildings including R2,R3,R4 over 3 stories and all R1 Revised August 2016 <br /> Project Title: Avaire Apartments Renovation Date 2/13/2017 <br /> Exterior Lighting For Building Department Use <br /> o Zone 1 •Zone 2 0 Zone 3 0 Zone 4 <br /> Zone Table C405.5.2(1) <br /> Specified by jurisdiction. Zone selection required to enable LTG-EXT form <br /> Calculation Area • O Addition- 0 Addition <br /> stand atone +existing <br /> o Alteration with<50% Alteration with a 50%ext. <br /> ext.wattage replaced wattage replaced <br /> Building Grounds o Efficacy>80 lumens/watt 0 Exemption <br /> Applies to luminaires <br /> > 100 Watts Q Controlled by motion sensor Luminaires do not exceed 100 Watts <br /> Tradable Maximum Allowed Lighting Wattage NOTE 1 Base Site Allowance: 600 <br /> Area(ft`),perimeter Hllowea vvans Hnowea vvans <br /> Tradable Surfaces Surface Description (If)or#of items per ft2 or per If x ft2(or x If) <br /> Main Entry Door Concrete 3 20W/LF door 60 <br /> Grounds Walkways <10 wide Concrete 60 0.7 W/LF 42 <br /> Other Entry Door Concrete 3 20W/LF door 60 <br /> Total Allowed Tradable+Site Allowance Watts: 762 <br /> Tradable Proposed Lighting Wattage NOTE2 - <br /> Number of Watts per Watts <br /> Tradable Surface Fixture Description NOTE 3,4 Fixtures Fixture NOTE 5 Proposed <br /> Main Entry Door Sconce Lighting(L6) 1 16 16 <br /> Grounds Walkways <10 wide Sconce Lighting(L6) 4 16 64 <br /> Other Entry Door Sconce Lighting(L6) 1 16 16 <br /> Total proposed tradable watts may not exceed the sum of total allowed tradable Total Proposed Tradable Watts: 96 <br /> watts plus the base site allowance. Any base site allowance not needed to <br /> make tradable watts complycan be applied to individual non-tradable <br /> Non-Tradable Maximum Allowed Lighting Wattage'"" <br /> $ g g Site Allowance Remaining: 600 <br /> Area(ft2),perimeter Allowed Watts Allowed Watts <br /> Non-Tradable Surfaces Surface Description (If)or#of items per ft2 or per If x ft2(or x If) <br /> Non-Tradable Proposed Lighting Wattage NOTE2 <br /> Number of Watts per Watts <br /> Non-Tradable Surface Fixture Description NOTE 3,4 Fixtures Fixture NOTE 5 Proposed <br /> Non-tradable proposed watts may not exceed allowed watts for any individual Non-Tradable Watts Exceeding LPA: 0 <br /> surface unless the total excess watts for all non-tradable surfaces are less than Remaining Site Allowance: 600 <br /> the remaining site allowance. <br /> Exterior Lighting COMPLIES WITH MAX. ALLOWANCE <br /> Note 1-List all unique exterior sufaces per Table C405.5.2(2)that occur in the project scope.Select exterior surface categories from drop <br /> down menu. <br /> Note 2-List all proposed lighting fixtures including existing-to-remain fixtures. <br /> Note 3-For proposed Fixture Description,indicate fixture type,lamp type,number of lamps in the fixture, and ballast type(if applicable). <br /> Note 4-Existing-to-remain fixtures shall be included in the Tradable and Non-Tradable Proposed Lighting Wattage tables in the same manner <br /> as new fixtures. Identify as existing in fixture description. <br /> Note 5-For proposed Watts/Fixture enter the luminaire wattage for installed lamp and ballast using manufacturer or other approved source. <br /> For <br /> luminaires with screwin lamps,enter the manufacturer's listed maximum input wattage of the fixture(not the lamp wattage). For low 7 <br />