607 SE EVERETT MALL WAY NORTH CORNER STUDIOS 2019-01-28

Exterior Lighting LTG-EXT 2015 Washington State Energy Code Compliance Forms for Commercial Buildings including R2,R3,R4 over 3 stories and all R1 Revised August 2016 Project Title: NORTHCORNER STUDIOS(FITNESS CENTER) Date 8.29.17 Exterior Lighting For Building Department Use Clone 1 Clone 2 Clone 3 O Zone 4 Zone Table C405.5.2(1) Specified by jurisdiction. Zone selection required to enable LTG-EXT form Calculation Area C °Addition-stand Addition alone v+existing nAlteration with<50% Iteration with>_50%ext. ext.wattage replaced •-Avattage replaced Building Grounds E Efficacy>80 lumens/watt C Exemption Applies to luminaires> 100 Watts Controlled by motion sensor Tradable Maximum Allowed Lighting Wattage N°TE t Base Site Allowance: 0 Area(ft2),perimeter(If) Allowed Watts Allowed Watts Tradable Surfaces Surface Description or#of items per ft2 or per If x ft2(or x If) Total Allowed Tradable+Site Allowance Watts: Tradable Proposed Lighting Wattage NOTE 2 Number of vvans per Watts Tradable Surface Fixture Description NOTE 3,4 Fixtures Fixture NOTE 5 Proposed Total proposed tradable watts may not exceed the sum of total allowed tradable watts Total Proposed Tradable Watts: plus the base site allowance. Any base site allowance not needed to make tradable watts comply can be applied to individual non-tradable categories. Non-Tradable Maximum Allowed Lighting Wattage NOTE 1 Site Allowance Remaining: 0 Area(ft2),perimeter(If) Allowed Watts Allowed Watts ' Non-Tradable Surfaces Surface Description or#of items per ft2 or per If x ft2(or x If) Non-Tradable Proposed Lighting Wattage NOTE 2 Number of vvans per Watts Non-Tradable Surface Fixture Description NOTE 3,4 Fixtures Fixture NOTES Proposed Non-tradable proposed watts may not exceed allowed watts for any individual surface Non-Tradable Watts Exceeding LPA: unless the total excess watts for all non-tradable surfaces are less than the remaining site allowance. Remaining Site Allowance: Exterior Lighting Note 1-List all unique exterior sufaces per Table C405.5.2(2)that occur in the project scope. Select exterior surface categories from drop down menu. Note 2-List all proposed lighting fixtures including existing-to-remain fixtures. Note 3-For proposed Fixture Description,indicate fixture type,lamp type,number of lamps in the fixture,and ballast type(if applicable). Note 4-Existing-to-remain fixtures shall be included in the Tradable and Non-Tradable Proposed Lighting Wattage tables in the same manner as new fixtures.Identify as existing in fixture description. Note 5-For proposed Watts/Fixture enter the luminaire wattage for installed lamp and ballast using manufacturer or other approved source.For luminaires with screw-in lamps,enter the manufacturer's listed maximum input wattage of the fixture(not the lamp wattage). For low voltage lighting,enter the wattage of the transformer.