3301 SEAWAY BLVD 2020-01-21 - Laserfiche WebLink

30. Construction plans submitted for permits shall demonstrate how development standards listed in Table 6.1 and the building design standards in Chapter 19.27 of the zoning code will be met. 31. The proposed mix of office and manufacturing uses will determine the minimum number of parking spaces required. Parking calculations are required to be provided at the time of building permit application(s). See also no. 30 above. 32. Since Buildings A and B are physically separated,parking provided on each site must meet the number of spaces required for the respective buildings, unless safe and direct pedestrian connections are provided between the two sites. 33. The proposed wetland fill has previously been mitigated pursuant to a mitigation plan(SEA95-025). No further mitigation is required. 34. Plans for development shall where disturbances within the Native Growth Protection Easement will occur, and if disturbances are to occur, provide a planting restoration plan for the disturbed area. The restoration would require native vegetation as required by the Planned Action mitigation measures cited above. 35. A split rail fence or other approved fence design shall be provided along the edges of the NGPE,and include NGPE signs as specified in Chapter 19.37 EMC. 36. The site is located within the Airport Compatibility Area as defined in Ordinance 3458-15(Copy enclosed). Before issuance of construction permits the applicant will need to demonstrate the applicable requirements of said ordinance have been met. 37. Prior to issuance of a construction permit the applicant shall sign a geological hazard areas covenant. The covenant form and language will be provided by the Planning Department. Fire Department Comments.Jim Ventura (425)257-8124 38. The International Fire Code requires that all new structures shall provide Fire Department access roads to within 150 feet exterior walking distance of all portions of the ground floor. Fire Department access roads(Fire Lanes)shall provide a minimum of 20 feet in width of unobstructed, paved driving surface,exclusive of shoulders,with a minimum clear height of 13'6". Inside turn radii must be 35 feet. Outside turn radii must be 55 feet. Slope approach and departure angles must not exceed 8 degrees. Fire lane grade must not exceed 10 percent. Fire lane construction must comply with AASHTO H30 load capacity(74,000 GVW). Fire Lanes will be posted and maintained as required by the Fire Department. Unorthodox access which meets code requirements but is too unusual for •• crews will not be allowed. 39. Buildings greater than 30 feet high require ladder apparatus access in accordance with the 2012 International Fire Code,Appendix D, D105. The unobstructed width of the access in the immediate vicinity of the building shall be 26 feet. At least one of the required access routes shall be located within a minimum of 15 feet and a maximum of 30 feet from the building and shall be positioned parallel to one entire side of the building. 40. Access-O.K.as shown on the site plan reviewed. 41. One new Knox Box is required for each building(A and B). Please install by the sprinkler/alarm room door. Order Model#3270 at www.everettfire.org. 42. Per field evaluation by the Fire Marshal's Office_fire lanes shall be provided as required in Everett Municipal Code 46.44. Fire lanes shall be identified by red curbs with white stenciling stating"NO