Laserfiche WebLink
9-29.2(2)A Standard Duty Cable Vaults and Pull Boxes <br /> Section 9-29.2(2)A is supplemented with the following: <br /> Both the slip-resistant lid and slip-resistant frame shall be treated with Mebac#1 as <br /> manufactured by IKG industries, or SIipNOT Grade 3-coarse as manufactured by W.S. Molnar <br /> Co. Where the exposed portion of the frame is 1/2 inch wide or less the slip-resistant treatment <br /> may be omitted on that portion of the frame. The slip-resistant lid shall be identified with <br /> permanent marking on the underside indicating the type of surface treatment ("Ml" for <br /> Mebac#1; or "S3" for SIipNOT Grade 3-coarse) and the year manufactured. The permanent <br /> marking shall be 1/8 inch line thickness formed with a stainless steel weld bead. <br /> 9-29.2(4) Cover Markings <br /> Section 9-29.2(4) is supplemented with the following: <br /> Junction Box Identification <br /> Junction boxes shall be marked "WSDOT"when the junction boxes are to be installed as part of <br /> a future raceway system in a bridge structure, vehicle barrier, pedestrian barrier, or roadway <br /> crossing and the future raceway system is not connected to an illumination, signal, interconnect, <br /> or ITS raceway system. <br /> Junction boxes, pull boxes and cable vaults containing only Traffic Signal Interconnect (fiber <br /> optics) cable shall be marked or embossed with the legend "COMM". <br /> 9-29.3(2) Electrical Conductors and Cable <br /> 9-29.3(2) <br /> Section 9-29.3(2) is supplemented with the following: <br /> 9-29.3(2) Video Detection Cable <br /> Coaxial cable or combination (composite/Siamese) cable for video detection shall be RG59/U <br /> with a manufacturer's rating of 600 Volts (Non UL - manufacturer's voltage rating of the <br /> insulation is acceptable). Combination cable shall be in accordance with the video detection <br /> system manufacturer's recommendations for the length of cable required. <br /> 9-29.3(2)B Multi-Conductor Cable <br /> Section 9-29.3(2)B is supplemented with the following: <br /> 9-29.3(2)B <br /> Two-conductor through ten-conductor unshielded control cable shall be size 14 AWG. <br /> 9-29.3(2)F Detector Loop Wire <br /> Section 9-29.3(2)F is revised to read as follows: <br /> 9-29.3(2)F <br /> Detector loop wire shall use 14 AWG stranded copper conductors, and shall conform to IMSA <br /> Specification 51-7, with cross-linked polyethylene (XLPE) insulation encased in a polyethylene <br /> outer jacket(PE tube). <br /> Swift Green Line—Corridor Stations Special Provisions SP207 <br /> May 2017 <br />