Laserfiche WebLink
I <br /> 2. Supplemental agreements between Owner and Contractor,if any, subsequent to the Owner's <br /> execution of the Contract; <br /> 3. Addenda; <br /> 4. The Contract; <br /> 5. Specifications, including, but not limited to,these General Conditions and other numbered <br /> Sections; <br /> 1 6. Supplementary Conditions, if any; <br /> 7. Drawings; <br /> 1 8. Change Orders; <br /> 9. City of Everett standard plans in effect as of the date Bids are opened; <br /> 10. Instructions to Bidders; <br /> 11. Contractor's completed Bid Form; and <br /> 12. Certifications and affidavits as required by this Contract and by law. <br /> These parts complement each other in describing the complete Work.Any requirement in one part binds <br /> as if stated in all parts.The Contractor shall provide any work or materials clearly implied in the Contract <br /> even if the Contract does not mention it specifically.Any inconsistency in the parts of the Contract shall <br /> 1 be referred to the Owner's Representative attention for a determination of the intended requirements. <br /> The Work required in one part must be furnished even if not mentioned in other parts of the Contract. If <br /> any part of the Contract requires Work that does not include a description for how the Work is to be <br /> performed,the Work shall be performed in accordance with standard trade practice(s). For purposes of <br /> the Contract, a standard trade practice is one having such regularity of observance in the trade as to justify <br /> an expectation that the Contractor will follow or observe the practice in performing the Work. In case of <br /> any ambiguity, disagreement or Dispute over interpreting the Contract,the Owner's Representative's <br /> decision will be final as provided in these General Conditions. <br /> Approved Shop Drawings,other Contractor's Submittals,and the reports and drawings of subsurface and <br /> physical conditions are not Contract Documents. <br /> 2. SPECIFICATIONS AND DRAWINGS <br /> 2.1. INTERPRETATION OF SPECIFICATIONS AND DRAWINGS <br /> The Specifications and Drawings are intended to be explanatory and supportive of each other. Work <br /> specified on the Drawings and not in the Specifications, or vice versa, shall be executed as if specified in <br /> both. In the event the Work to be done or matters relative thereto are not sufficiently detailed or <br /> explained in the Contract Documents,the Contractor shall immediately ask the Owner's Representative <br /> for further explanation and shall comply with such explanation. In the event of doubt or question arising <br /> ' respecting the true meaning of the Specifications or Drawings, Contractor shall refer to the Owner's <br /> Representative for his or her decision. <br /> The Specifications may vary in form, format and style. Some specification sections are written in varying <br /> ' degrees of streamlined or declarative style and some sections may be relatively narrative by comparison. <br /> Omissions of such words and phrases as"the Contractor shall," "in conformity with," "as shown," or"as <br /> specified" are intentional in streamlined sections. Omitted words and phrases shall be supplied by <br /> ' inference. Similar types of provisions may appear in various parts of a section or articles within a part <br /> depending on the format of the section. The Contractor shall not take advantage of any variation of form, <br /> format or style in making claims for extra Work. <br /> I <br /> General Conditions—007200-5 <br /> 1 <br />