Ordinance 4157 - Laserfiche WebLink

All such underground installations orsystems shall be • • approved by the appropriate utility company and shall adhere to all governing regulations including but not limited to the city and state applicable regulations and specific requirements of the appropriate utility. If the appropriate utility company determines that an underground system as proposed above cannot reasonably be installed according to accepted engineering practices, this requirement shall be waived upon receipt of a written notice from said utility to the Planning Commission setting forth said findings. All utility easements within a proposed plat shall be approved by the appropriate utility company before final acceptance of the plat and shall be shown in their exact location on the final drawing of said plat. Nothing in this Section or any other Section of this Ordinance in relation to underground wiring shall apply to power lines carrying a voltage of 15 KV or more, nor shall it be construed to prohibit the placement of pad-mounted transformers, terminal pedestals or other electrical and communications devices above ground, as determined by the appropriate utility involved. j. In the event that there are specific conditions which make a variation from these minimum standards desirable or necessary, a request for such variation shall be made as apecified in Section 8. 2. When the subdivider installs pavement, curbs, sidewalks, sanitary sewers, storm sewers, electrical utilities, and other inprovements, all such improvements shall be carried out according to the general design and installation standards approved by the City Engineer and all plans must be approved by the City Engineer before ai nstruction starts. Construction-work to• be inspected by the City En,gineer.,• the inspection cost to be paid by the developer. E. Requirements of the final Plat: The map of the final plat, subdivision, or dedication shall be submitted to the City Council or its authorized administrator in the form herewith prescribed: 1. All documents, maps, and survey notes shall contain the name of the subdivision, the name(s) of the subdivider(s), and the name of the registered land surveyors responsible to the subdivider(s). a. The final plat submitted shall be on tracing cloth and have a trimmed size of 18" x 22". 3. The final plat shall clearly show the following information: a. The names and boundary lines of all rights-of-way of public streets, all parks, playgrounds, and easements contained in the plat, subdivision, or dedication, and shall contain thereon, (13)