Interwest Construction Inc. 7/22/2020

CITY OF EVERETT SPECIAL PROVISIONS [Modified per Addendum #1] 1-10.3(2) Maintenance and Protection of Traffic Control When the Bid proposed includes an item for "Maintenance and Protection of Traffic Control", the Work required for this item shall be to: 1. Furnish and maintain signs, cones, barricades, flasher, and other channelization devices; 2. Provide supervisory personnel for all labor for traffic control; 3. Provide labor and necessary vehicle(s) for set-up and removal of construction signs and the traffic control devices that are placed daily; I 4. Provide labor and vehicles for patrolling and maintaining in position all of the construction signs and the traffic control devices; 5. Provide labor, material, and equipment necessary for cleaning up, removing I and replacing all construction signs and traffic control devices that are destroyed, damaged or lost during the life of the project; 6. Provide flagging or use of police officers for the convenience of the , Contractor, such as facilitating movement of equipment on the site, laying out or relocating traffic control devices and signs. 7. Cost associated with preparation and distribution of public notices involving 1 parking, street access or traffic issues. Upon failure of the Contractor to immediately provide flaggers, erect, maintain, and remove signs; or provide, erect, maintain, and remove other traffic control devices when ordered to do so by the Engineer, the City may without further notice to the Contractor or the Surety, perform any of the above and deduct all or the costs from the Contractor's payments. ' The Contractor shall be responsible for providing adequate flaggers, signs, and other traffic control devices for the protection of the worker and the public at all times regardless of whether or not the flaggers, signs, and other traffic control devices are ordered by the Engineer, or paid for by the City. The Contractor shall be liable for injuries and damages to persons and property suffered by reason of the Contractor's operations or negligence in connection therewith. 1-10.3(3) Not Used 1-10.3(4) Traffic Control Labor The Contractor shall furnish all personnel for flagging to control traffic during construction operations. Flaggers shall have a current certification (Flagging Card) from the State Department of Labor and Industries (WAC 296-155-305). Employees of the Contractor engaged in flagging or traffic control shall wear reflective vests and hard hats. During hours of darkness, white coveralls or white or yellow rain gear shall also be worn. The vests and other apparel shall be in conformance with Section 1-07.8. The Contractor shall furnish the MUTCD standard Stop/Slow paddles, except the minimum width shall be 24-inches, for the flagging operations. During hours of darkness flagger stations shall be illuminated to insure that flaggers can be easily seen without causing glare to the traveling public. The Contractor shall develop and use a method to ensure that flaggers have adequate warning of objects approaching from behind the flagger. All flaggers shall start a new job with an on-site orientation. This orientation must include, but not be limited to, the flagger's role and location on the job site, equipment, traffic patterns, communications and hazards specific to the work site. If off-duty uniformed police officers are not available for traffic control for Work within signalized intersections, Contractor may provide four flaggers. Flaggers are not Sewer 0 Division 1 —GENERAL REQUIREMENTS Addendum No. 1 WO No—UP3691 SP—138 May 2020