Laserfiche WebLink
. • <br /> KP Roof Repairs and Roof Improvements Project Section 07620 <br /> Community Transit, !TB#2019-028 Sheet Metal Flashing <br /> PART 1 -GENERAL <br /> 1.01 DESCRIPTION <br /> A. Work includes new metal flashings at roof intersections, wall intersections, curbs, edges and <br /> mechanical penetrations and as otherwise required for a complete, weatherproof installation. <br /> 1. KP-A: New sheet metal/clad metal flashings, reinforced fluid applied flashings, and <br /> sealant for the existing sheet metal roof assembly. <br /> 2. KP-C South Canopy: New sheet metal flashing for the new exterior sheet metal siding <br /> and the new single ply membrane roofing. <br /> 3. KP-Fuel Island: New sheet metal flashing for the new exterior sheet metal siding and <br /> new single ply membrane roofing. <br /> 4. KP-Vault: New sheet metal flashing for the new sheet metal roof panels. <br /> 5. KP-Bus Wash: New sheet metal/clad metal flashings and new reinforced fluid applied <br /> flashings for several repairs of the existing sheet metal roof assembly. <br /> 1.02 RELATED SECTIONS <br /> A. Division 1 General Requirements <br /> B. Division 7 Section 07500"Single Ply Membrane Roofing" <br /> C. Division 7 Section 07600"Sheet metal Roofing and Siding" <br /> 1.03 REFERENCES <br /> A. SMACNA, Architectural Sheet Metal Manual, 5th Edition. <br /> 1.04 SUBMITTALS <br /> A. Product data: Submit the name of the manufacturer, specification numbers, color samples for <br /> exposed products, and product names of all materials proposed for use in the work. Include in <br /> submittal installation instructions and general recommendations for each principal product <br /> required. Include data substantiating that the materials comply with requirements. <br /> B. Shop Drawings: Show installation layout of sheet metal flashing and trim, including plans, <br /> elevations, and keyed details. <br /> C. Samples: Submit 6"x6"sample of prefinished sheet metal to be utilized in flashing transitions. <br /> 1.05 PERFORMANCE REQUIRMENTS <br /> A. General: Sheet metal flashing and trim assemblies shall withstand wind loads, structural <br /> movement, thermally induced movement, and exposure to weather without failure due to <br /> defective manufacture, fabrication, installation, or other defects in construction. Completed <br /> sheet metal flashing and trim shall not rattle, leak, or loosen, and shall remain weather-tight. <br /> B. SPRI Wind Design Standard: Manufacture and install copings and roof edge flashings tested <br /> according to SPRI ES-1 and capable of resisting design pressured calculated in accordance <br /> with ASCE 7-10. <br /> Construction Documents <br /> 07620-1 0//3 <br />