10225 1ST DR SE 2021-02-25 - Laserfiche WebLink

5. A paved driveway must be installed per City of Everett Design Standards prior to final approval. A 10 foot by 20 foot T-turnaround is required for Lot 2. The turnaround must be 5 feet off of the front lot line and shall not be used for parking. The turnaround must be screened per EMC 18.28.080.E.1. 6. Full standard half street improvements are required to 1st Drive SE including curb, gutter, sidewalk and drainage control per City Design Standards. Roadway should be coordinated with the frontage improvements at 10230 1st Drive SE with 32 feet total roadway width. The level of frontage improvements required is determined by the City Engineer or his designee and shall be based on the traffic and drainage impacts anticipated. 7. The construction plans must be designed from a site survey performed by a licensed State of Washington land surveyor. 8. All exposed ground must be reseeded within 30 days of the completion of construction. If reseeding is not practical due to weather or season problems, the ground must be covered with mulch as directed by the City Engineer. 9. Temporary erosion control measures for construction activity must be operational prior to commencement of any clearing or earthwork. 10. Any grading/fill on this site shall be done so as to not impact the surrounding properties. 11. City streets are to be kept clear of dirt and debris at all times during construction. Dust suppression and street cleaning must occur as directed by the Public Works Inspector. 12. A one-year guarantee is required on the public improvement for an amount not less than 10%of the cost of construction and shall run for one year from the date of final approval. 13. A water service and sewer stub must be installed to Lot#2 prior to final plat approval. 14. Stormwater shall be managed in accordance with the stonnwater standards in effect at the time a complete building permit application,or other type of construction permit application, is received by the City. The submittal of a complete short subdivision application prior to 12/31/2016 does not vest a project to pre-2017 stormwater management standards. 15. The required yard area must be shown on the final plat or short plat map. 16. The project's Public Works Project number is SS1202-2016-005. This number must be noted at the top and bottom of the final plat map. 17. Provide at least 4 parking spaces per lot, consistent with regulations under EMC 18.28.140. Lot 2 shall place the garage 35 feet from the front property line. 18. The parking layout must be consistent with City of Everett Standards. 19. All parking areas shall be paved. Preliminary Approval Project No.SSI6-005 8 of