1920 100TH ST SE 2021-12-13 - Laserfiche WebLink

A& r1 Lighting, Motor, and bectrical Permit Checklist, PQ,.'2 LTG-CHK 2015 Washington State Energy Code Compliance Forms for Commercial Buildings including R2, R3, R4 over 3 stories and all R1 Revised July 2016 Project Title: SEA MAR EVERETT MEDICAL CLINIC Date 6/18/2019 The following information is necessary to check a permit application for compliance with the lighting, motor, and electrical requirements in the Washington State Energy Code, Commercial Provisions. Applicability Location in Building Department (yes,no,na) Code Section Component Compliance information required in permit documents Documents Notes C405.2.5 - Hotel/motel guest Indicate method of automatic control - vacancy or captive key NA Item 3 rooms control of all installed luminaires and switched receptacles in guest room C405.2.5 - Supplemental task Indicate method and location of automatic shut-off vacancy No Item 4 lighting control for supplemental task lighting, including under -shelf or under -cabinet lighting Indicate on plans eligible non -visual lighting applications, include sq. ft. area of each lighting control zone; Indicate on plans that non -visual lighting are controlled C405.2.5 - Lighting for non- No Item 5 visual applications independently from both general area lighting and other lighting applications within the same space; Indicate method of manual lighting control and applicable automatic lighting control Indicate on plans that lighting equipment for sale or demonstration are controlled independently from both general C405.2.5 - Lighting equipment area lighting and other lighting applications within the same NA Item 6 for sale or space; demonstration Indicate method of manual lighting control and applicable automatic lighting control Identify on plans egress fixtures that function as both normal A0.01 and emergency means of egress illumination; Provide calculation of lighting power density of total egress YES C405.2.5 - Means of egress lighting; If total egress lighting power density is greater than 0.02 W/sq. Item 7 lighting ft., indicate on plans egress fixtures requiring automatic shut-off during unoccupied periods; Indicate method of automatic shut-off control Indicate on exterior lighting plans and fixture schedules the automatic lighting control method, control sequence, and locations served; For building facade and landscape lighting, indicate automatic Exterior lighting controls shut off lighting as a function of dawn/dusk and fixed No C405.2.7 controls opening/closing time; --- -- — For all other exierior lighting, indicate automatic controls shut off ---- lighting as a function of available daylight; include control sequence that also reduces lighting power by at least 30% between 12am-6am, or from 1 hour after closing to 1 hour before opening, or based upon motion sensor Exterior building For building grounds fixtures greater than 100 watts, indicate on No C405.5.1 grounds lighting plans whether fixtures have efficacy greater than 80 lumens or; controls are controlled by motion sensor, or are exempt lighting per C405.5.2 Area controls - Indicate location(s) of master control switch(es) intended to Master control control multiple independent switches; circuit breaker may not No C405.2.5 switches and circuit be used as a master control switch; - ---- Verify that no 20 amp circuit controlled by a single switch or power limit automatic control is loaded beyond 80% To comply with additional efficiency package option, indicate on plans all interior lighting fixtures that are individually addressed and provided with continuous dimming, or exception taken; No C406.4 Enhanced digital Include calculation of percent total installed interior lighting lighting controls power that is configured with required enhanced lighting control functions (min 90% to comply with additional efficiency package option) If claiming lighting system commissioning exemption provide supporting calculation; Identify applicable commissioning documentation requirements C405.13 Lighting system C408.3 functional testing per Section C408 or eligibility for exception; Provide written procedures for functional testing of all automatic controls and describe the expected system response