Laserfiche WebLink
• • • ' TOO . • - . - • I - - I • . ti <br /> 2018 WSEC Requirements for Commercial Buildin, cluding Group R2,R3&R4 over 3 stories&all R1 -- •. inistered by©2021 NEEA,All rights reserved <br /> The following information is necessary to check a permit application for compliance with the lighting systems,motors and electrical system requirements in the <br /> Washington State Energy Code,Commercial Provisions. <br /> For questions about this report,contact WSEC Commercial Technical Support at 360-539-5300 or via email at com.techsupport@waenergycodes.com <br /> • <br /> YES C405.4.2.2 Space-By-Space Demonstrate that total proposed wattage does <br /> Method not exceed maximum allowed wattage; <br /> identify locations of space types on plans, <br /> including retail display areas and areas with <br /> display,highlight and decorative lighting; <br /> provide WSEC exterior lighting compliance <br /> reports <br /> ADDITIONAL EFFICIENCY CREDITS-REDUCED INTERIOR LIGHTING POWER DENSITY <br /> NA C406.3.1 Reduced interior To comply with additional efficiency credit, <br /> C406.3.2 lighting power demonstrate that total connected interior <br /> density lighting wattage is 10%or 20%less than the <br /> total maximum allowed lighting wattage for <br /> the area the reduced lighting power credit is <br /> being applied to;indicate whether lighting <br /> power allowance is based on the building area <br /> method or space-by-space method;provide <br /> WSEC exterior lighting compliance reports <br /> NA C406.3 Reduced interior For project with dwelling units,to comply <br /> lighting power with additional efficiency credit indicate in <br /> density-dwelling lighting fixture schedule that lamps within <br /> unit lamp efficacy installed interior luminaires have an efficacy <br /> rating of at least 65 lumens per watt;include <br /> number of lamps and provide calculations that <br /> demonstrate at least 95%of lamps have this <br /> efficacy rating <br /> EXTERIOR LIGHTING POWER&EFFICACY <br /> NA C405.5.2 Total connected Include all luminaires in exterior lighting <br /> exterior lighting fixture schedule;indicate fixture types,lamps. <br /> power ballasts,and manufacturer's watts per fixture <br /> for the installed lamp <br /> NA Identify exterior applications eligible for <br /> lighting power exemption on plans and in <br /> WSEC exterior lighting compliance reports; <br /> indicate exception applied <br /> NA C405.5.3(1) Exterior lighting zone Indicate building exterior Iighting zone as <br /> specified by the AHJ <br /> NA C405.5.1 Exterior building For building grounds fixtures rated at greater <br /> grounds lighting than 50 watts,indicate rated lamp efficacy(in <br /> lumens per watt)in fixture schedule <br /> EXTERIOR LIGHTING POWER CALCULATION <br /> NA C405.5.3 Tradable allowances Demonstrate that total proposed tradable <br /> surface wattage does not exceed maximum <br /> allowed tradable surface wattage(including <br /> base site allowance);identify locations of <br /> tradable surfaces on plans;provide WSEC <br /> exterior lighting compliance reports <br /> Page 6/10 <br />