2300 MERRILL CREEK PKY CADENCE AEROSPACE 2024-05-03

• 2015 WSEC Compliance Forms for Commercial Buildings including R2, R3, & R4 over 3 stories and all R1 Revised Jun 2016 Minimum Requirements This table summarizes prescriptive compliance requirements for opaque elements and fenestration. Refer for Prescriptive Compliance to Tables C402.1.3, C402.1.4 and C402.4 in the 2015 WSEC for important footnotes that apply to these tables. Refer to Section C402 for all applicable requirements that apply for each envelope element type and applicable exceptions. Refer to Section C410 for all applicable information for refrigerated spaces. Prescriptive Path Table C402.1.3 Notes I,7 Insulation Min#mum R-Value Table C402.1.4 Notes 1,2 Assembly Maximum U-factor Occu ancv Grou All Other Group R All Other Group R Opaque Elements Roofs Insulation Entirely above Deck R-38 c.i. R-38 c.i. U-0.027 U-0.027 Metal Building with thermalspacer block Note 3 R-25 + R-1 I Ls R-25 + R-11 Ls U-0.031 U-0.031 Attic and Other R-49 R-49 U-0.021 U-0.021 Joist or single rafter R-49 R-49 U-0.027 U-0.027 Walls, Above grade Mass R-9.5 c.i. Note 6 R-13.3 c.i. U-0.104 Note 6 U-0.078 Mass transfer deck slab edge No R-Value for pre criptive compliance U-0.200 U-0.200 tal But in - R-19 c.i. U-0.052 U-0.052 Steel Framed R-13+R-10c.i. R-19+R-8.56. U-0.055 U-0.055 Wood Fra-me-d and Other - w Int. ra R-21 w/ int. frame U-0.054 U-0.054 Below Grade Wall Note 4 Same as above grade Same as above grade Floors Mass R-30 c.i. R-30 c.i. U-0.031 U-0.031 Steel Joist R-38 + R-10 c.i. R-38 + R-10 c.i. U-0.029 U-0.029 Wood Framed and Other R-30 R-30 U-0.029 U-0.029 Slab -On -Grade Floors Unheated R-10 for 24 in. (from top of slab) F-0.54 F-0.54 Heated Note 5 R-10 perimeter & under entire slab F-0.55 F-0.55 Opaque Doors Swinging No R-Value for prescriptive compliance U-0.37 U-0.37 Nonswin in(Roll-up or sliding) R-4.75 I R-4.75 U-0.34 U-0.34 Table C402.4 - 0-30 % of wall area, or 30%-40% per Section C402.3.1.1 DLZ or Section C402.3.1.4 DOAS Section C402.3.1.3 High Performance o Fenestration Option - 0-40/ of well area Fenestration Assembly Maximum ti-factor Notes 1,2 Vertical Fenestration Nonmetal framing U-0.30 U-0.30 U-0.28 U-0.28 Metal framing (fixed) U-0.38 U-0.38 U-0.34 U-0.34 Metal framing (operable) U-0.40 U-0.40 U-0.36 U-0.36 Entrance doors U-0.60 U-0.60 U-0.60 U-0.60 Skylights Skylights U-0.50 U-0.50 U-0.50 U-0.50 Fenestration Assembly Maximum SHGC Factor Vertical Fenestration PF<0.2: north - SHGC=0.53; all other SHGC=0.4 0.25 PF < 0.5: north - SHGC-0.58; all other - SHGC-0.48 PF >_ 0.5: all orientations - SHGC-0.64 PF<0.2: north - SHGC=0.46; all other SHGC=0.35 0.25 PF < 0.5: north - SHGC-0.51; all other - SHGC-0.42 PF >_ 0.5: all orientations - SHGC-0.56 Skylights SHGC-0.35 SHGC-0.35 (`410.2 Refrigerated Spaces Insulation Insulation Minimum R-Value Assembly Maximum U-factor Freezers - Walk-in and Warehouse Roof / Ceiling R-32 U-0.030 Wall R-32 U-0.030 Door R-32 U-0.030 Door - transparent reach -in triple -pane, heat -reflective treated or gas Floor R-28 U-0.035 Coolers - Walk-in and Warehouse Roof / Ceiling R-25 U-0.039 Wall R-25 U-0.039 Door R-25 U-0.039 Door - transparent reach -in double -pane, heat -reflective treated & gas fill, or comply with freezer door req. Floor No Requirement