McClure & Sons Inc. 4/18/2022 - Laserfiche WebLink

Section 40 90 00 PROCESS CONTROL SYSTEM GENERAL PROVISIONS b. With rating for the environment installed. 9. Terminate all wiring on terminal strips, splicing wiring is not acceptable. 10. Wire that terminates on screw type terminals shall be provided with a spade or loop type end connector. 11. For all indicating transmitters that are mounted inside enclosures, provide a window in the enclosure so that the display can be viewed without opening the enclosure. 12. Instrumentation supplier shall provide installation inspection, calibration and training as required for proper installation. B. DOOR-SWITCHES 1. Provide door security switches at locations indicated on the Drawings. I 2. Install such that the switch contacts are closed when the door is closed. Magnetic type with contacts normally open held closed when door is closed. Switches shall have anodized finish and be furnished with 3-foot stainless steel armored cable. Sentrol 2500 series or accepted equal. 2.12 WIRE MARKERS: A. Field installed wire markers shall be T&B, SHRINK-KON HVM or accepted equal. 2.13 SPARE PARTS A. In addition to spare parts mentioned elsewhere in this section, the Contractor o tractor shall supply the following spare parts for use by the Owner. All spare parts shall be shipped with the equipment. 1. Qty 1 spare (non-installed) PLC input and output card of each type used. 2. Qty 1 spare power supply of each type and rating used. 3. Qty 1 Relay of each type used or 10 % whichever is the greater amount. 4. Qty 2 lamps of each type used or 100% whichever is the greater amount. 5. Qty 200% spare fuses (two spare fuses for each fuse supplied). 6. Provide 5 spare nameplates 3" square or less with 20 letters 1/2" or less to be specified by the Owner. 7. Qty 1 Copy of final PLC program on a thumb drive. I I I City of Everett 40 90 00-13 January 2022 Evergreen Pump Station Modifications UP3747-3 Issued for Bid