305 SE EVERETT MALL WAY VISION WORKS 2022-06-28

LV IV VV%Jt.V I‘CIjUII GIIICI IW IV1 VVIluncIciai a+w�a�u�y.,n�wawu��v.vu.�...�,........-. �--. ----- ------ -- The following information is necessary to check a mechanical permit application for compliance with the mechanical systems and equipment requirements in the -Washington State Energy Code,Commercial Provisions. For questions about this report,contact WSEC Commercial Technical Support at 360-539-5300 or via email at com.techsupport@waenergycodes.com C408.1.2.2 Functional Identify in plans and specifications the performance testing intended operation of all equipment and criteria controls during all modes of operation, including interfacing between new and existing-to-remain systems C408.2.2 Air system and Indicate in plans that air and fluid flow rate; hydronic system shall he tested and balanced within the balancing tolerances defined in the specifications; indicate systems shall be balanced in a manner to first minimize throttling losses,then • adjusted to meet design flow conditions • Air system balancing Indicate devices that provide the capability to • devices balance all supply air outlets.zone terminals and air handling equipment requiring system balancing . C4tt8.2.2.2 Hydronic system Indicate devices that provide the capability to balancing devices isolate,balance and measure flow across all hydronic equipment requiring system balancing including heating and cooling coils and pumps;or exception applied PROJECT CLOSE OUT DOCUMENTATION YES C103.6 Documentation and Indicate in plans that project close out • project close out documentation and training of building submittal operations personnel is required for all requirements mechanical components,equipment and systems governed by this code;indicate close out documentation shall include:record • documents,O&M manuals,applicable WSEC mechanical equipment compliance reports and calculations • 2 �