7206 WETMORE AVE 2023-01-17 - Laserfiche WebLink

6.2 Installing Clamps w/ QClick Technology° Quick Mount PV's patented QClick Technology is a special clip with which the module clamps are fastened in the QRail. You need only a 5mm Allen key for the installation. The QClick is inserted from above into the top channel of the QRail. Installation Steps: "'Or � ■ Insert the QClick at a slight angle into the rail channel. ■ While holding it firmly in place, rock the QClick upright until it clicks into place. Removing the Clamps w/ QClick: Image 6.2.1 Spreaders on the inside of the QClick are designed so that once the bolt of the Installation of clamps w/QClick Technology clamp has been tightened, the QClick cannot unlatch from the rail. To remove a QClick, first unscrew the bolt so that it is clear of the spreaders T T then, with pressure on the QClick "legs," rock the QClick to unlatch it from the rail and lift it out. Moving the Clamps w/ QClick: The shape of the QClick corresponds exactly to the profile of the rail channel. It's been deliberately designed not to slide easily in orderto Image 6.2.2 prevent unintentional slipping in vertical rail installations. To move the QClick, Removing clamps w/QClick Technology loosen the bolt of the clamp so that it is not contacting the spreaders in the QClick body. Then, while pressing lightly on the bolt, squeeze the QClick legs together and slide the QClick along the channel. _ Clamp bolt No `- QClick Spreaders QClick The outside edge of the QClick Legs ' QClick must be installed QClick Hooks • at least 1/2" from end or rail at a splice location. DANGER Image 6.2.3 QClick Components Material damage caused by deformed QClicks ' If clearly deformed QClicks are used, the safety of the module attachment is not assured. PV modules can fall and be damaged. Use only QClick where the legs are parallel to each other and • you can clearly hear them clicking into the rail channel. Replace the deformed QClick prior to CAUTION installation. B1 7.2.3-46 25 Jul-2019, Rev 4.2