Laserfiche WebLink
ig ling, Y otor an• ectrica -equirements 1st, pg 4 o 11 <br /> 2018 WSEC Requirements for Commercial Buildings including Group R2,R3&R4 over 3 stories&all R1-- Administered by©2022 NEEA,All rights reserved <br /> The following information is necessary to check a permit application for compliance with the lighting systems,motors and electrical system requirements in the <br /> Washington State Energy Code,Commercial Provisions. <br /> For questions about this report,contact WSEC Commercial Technical Support at 360-539-5300 or via email at com.techsupport@waenergycodes.com <br /> NA C405.2.5, Supplemental task Indicate method and location of manual and <br /> Item 1 lighting automatic shut-off control(occupant sensor or <br /> time switch)for supplemental task lighting, i f <br /> including under-shelf or under-cabinet <br /> lighting I i <br /> NA C405.2.5, Lighting equipment Indicate on plans that lighting equipment for <br /> Item 1 for sale or sale or demonstration are controlled <br /> demonstration independently from both general area lighting <br /> and other lighting applications within the <br /> same space <br /> � R <br /> NA Indicate manual and automatic(occupant <br /> sensor or time switch)lighting control <br /> methods <br /> NA C405.2.5, Lighting for non- Identify all eligible non-visual lighting <br /> Item 4 visual applications applications on plans;indicate that the area <br /> served by each control device does not <br /> exceeds 4,000 sf <br /> NA Indicate on plans that non-visual lighting are <br /> controlled independently from both general <br /> area lighting and other lighting applications <br /> within the same space <br /> ' I I <br /> NA Indicate method of manual lighting control <br /> and applicable automatic lighting control <br /> NA C405.2.5, Means of egress Identify on plans egress fixtures that function only exit signs <br /> Item 5 lighting as both normal and emergency means of <br /> egress illumination <br /> YES Provide calculation of lighting power density I 9/1155=.008 sf <br /> of total egress lighting <br /> NO if total egress lighting power density is greater <br /> than 0.02 W/sq.ft.,indicate on plans egress <br /> { fixtures requiting automatic shut-off during <br /> unoccupied periods <br /> NA Indicate method of automatic shut-off control <br /> NA C405.4.1 Lighting control of Indicate that exempt interior lighting <br /> C405.4.2 exempt interior equipment and lighting located within spaces <br /> lighting that are eligible for a lighting power <br /> exemption are controlled independently from <br /> non-exempt and general area lighting <br /> t 405.2.6 Exterior lighting I For decorative exterior lighting,indicate on <br /> controls pl;ms automatic daylight shut-off controls;or <br /> exception taken <br /> I For exterior lighting that is not decorative, <br /> indicate on plans automatic daylight or dine- <br /> I switch shut-off controls and setback controls; <br /> or indicate exception taken <br /> For lighting requiring setback controls, <br /> include control sequence that reduces liglntiug <br /> power by at least 30%between 12am-6am.or <br /> from I hour after closing to I hour before <br /> opening.or based upon motion sensor <br /> Page 4/11 <br />