Laserfiche WebLink
2018 WSEC Requirements for Commercial Buildings including Group R2,R3&R4 over 3 stories&all R1 -- Administered by©2022 NEEA,All rights reserved <br /> The following information is necessary to check a permit application for compliance with the lighting systems,motors and electrical system requirements in the <br /> Washington State Energy Code,Commercial Provisions. <br /> For questions about this report,contact WSEC Commercial Technical Support at 360-539-5300 or via email at com.techsupport@waenergycodes.com <br /> NO ( i Identify lighting equipment eligible for I didn't apply <br /> lighting power exemption in fixture schedule exemptions <br /> and in WSEC interior lighting compliance <br /> reports;indicate the exception applied <br /> C405.1 Lighting in dwelling I For all installed luminaires,include lamp type <br /> C405.1,1 i units(multifamily D and number of lamps in lidating fixture <br /> schedule:for lamps that are not LED.T-S or <br /> small diameter fluorescent,indicate efficacy <br /> of other lamp types is 65 lumens per watt or <br /> Qaeater <br /> For all installed luminaires,indicate in <br /> lighting fixture schedule whether complying_. <br /> via lighting power density or by qualifying <br /> i ! lamp type;if by lamp type,include number of <br /> I j ; lamps <br /> I ; <br /> ! !! <br /> For all installed luminaires,indicate in R <br /> ! i 1 lighting fixture schedule whether complying <br /> via lig.htina power density or by qualifying i ; I <br /> lamp type;if by lamp type,include number of I <br /> lumps i I <br /> INTERIOR LIGHTING POWER CALCULATION-INDICATE COMPLIANCE PATH TAKEN <br /> YES C405.4.2.1 Building Area Demonstrate that total proposed wattage per see forms included <br /> Method building area does not exceed maximum here <br /> allowed wattage per building area;identify <br /> locations of building areas on plans;provide <br /> WSEC exterior lighting compliance reports <br /> NO C405.4.2.2 Space-By-Space Demonstrate that total proposed wattage does <br /> Method not exceed maximum allowed wattage; <br /> identify locations of space types on plans, <br /> including retail display areas and areas with <br /> display,highlight and decorative lighting; <br /> provide WSEC exterior lighting compliance <br /> reports <br /> ADDITIONAL EFFICIENCY CREDITS-REDUCED INTERIOR LIGHTING POWER DENSITY <br /> fi NO C406.3.1 Reduced interior To comply with additional efficiency credit, don't need points for <br /> C406.3.2 lighting power demonstrate that total connected interior this TI <br /> density lighting wattage is 10%or 20%less than the <br /> total maximum allowed lighting wattage for <br /> the area the reduced lighting power credit is <br /> being applied to;indicate whether lighting <br /> power allowance is based on the building area <br /> method or space-by-space method;provide <br /> WSEC exterior lighting compliance reports <br /> C406.3 Reduced interior For project with dwelling units,to comply <br /> lighting power j with aadditional efficiency credit indicate in <br /> density-dwelling i lighting fixture schedule that lamps within <br /> unit lamp efficacy installed interior luminaires have an efficacy <br /> i f ;rating of at least 65 lumens per watt:include <br /> number of lamps and provide calculations that <br /> demonstrate at least 95%of lamps have this <br /> efficacy rating <br /> EXTERIOR LIGHTING POWER&EFFICACY <br /> Page 6/11 <br />