Laserfiche WebLink
ig ting, Y otor an• ectrica -equirements 1st, pg 7 o 11 <br /> 2018 WSEC Requirements for Commercial Buildings including Group R2,R3&R4 over 3 stories&all R1 -- Administered by©2022 NEEA,All rights reserved <br /> The following information is necessary to check a permit application for compliance with the lighting systems,motors and electrical system requirements in the <br /> Washington State Energy Code,Commercial Provisions. <br /> For questions about this report,contact WSEC Commercial Technical Support at 360-539-5300 or via email at com.techsupport@waenergycodes.com <br /> C405.5.2 Total connected include all luminaires in exterior lighting ! <br /> exterior lighting ;fixture schedule;indicate fixture types,lamps, <br /> power r V t ballasts,and manufacturer's watts per fixture ! 3 <br /> for the installed lamp <br /> Identify exterior applications eligible for <br /> lighting;power exemption on plans and in <br /> WSEC exterior lighting cortapliance reports: <br /> indicate exception applied <br /> C405.5.3(1) 1 Exterior lighting zone Indicate building exterior lighting zone as <br /> specified by the.3H7 <br /> C405.5.1 Exterior building For building grounds fixtures rated at greater <br /> grounds lighting than 50 walls,indicate rated lamp efficacy tin <br /> lumens p°r watt)in fixture schedule <br /> EXTERIOR LIGHTING POWER CALCULATION <br /> a I f ! <br /> C405.5.3 Tradable allowance, Demonstrate that total proposed tradable 13 <br /> surface wattage does not exceed maximum <br /> allowed tradable surface wattage(including ! j <br /> } base site allowance);identify locations of <br /> tradable surfaces on plans:provide WSEC <br /> exterior lighting compliance reports { 1 <br /> ! f Demonstrate that proposed wattage per non- <br /> tradable surface type does not exceed <br /> maximum allowed wattage per non-tradable <br /> surface type(including base site allowance <br /> remaining after tradable allowance {' <br /> calculation);identify locations of non-tradable <br /> ! i surfaces on plans:provide WSEC exterior <br /> lighting compliance reports <br /> LIGHTING ALTERATIONS <br /> NA C503.6.1 Interior and parking �Where>_50%of existing luminaires in an <br /> garage lighting interior space or parking garage are replaced; <br /> iI fixture alterations indicate compliance path(building area or <br /> space-by-space method);include all new and <br /> } existing-to-remain luminaires in WSEC <br /> interior lighting compliance reports;indicate <br /> proposed lighting wattage does not exceed <br /> maximum allowed per compliance path <br /> NA Where<50%of existing luminaires in an <br /> interior space or parking garage are replaced; <br /> indicate total existing lighting wattage in each <br /> space prior to alteration;include all new and <br /> existing-to-remain luminaires in WSEC <br /> interior lighting compliance reports;indicate <br /> proposed total lighting wattage in alteration <br /> area does not exceed total existing lighting <br /> wattage prior to alteration <br /> Where>_50%of existing exterior lighting <br /> wattage is replaced;include all new and <br /> existing-to-remain luminaires in WSEC <br /> exterior lighting compliance reports;indicate <br /> proposed total exterior lighting wattage does <br /> not exceed maximum allowed <br /> • <br /> Page 7/11 <br />