Laserfiche WebLink
ig ting, Y otor an• ectnca 'equirements ist, pg : o 11 <br /> • 2018 WSEC Requirements for Commercial Buildings including Group R2,R3&R4 over 3 stories&all R1 -- Administered by©2022 NEEA,All rights reserved <br /> The following information is necessary to check a permit application for compliance with the lighting systems,motors and electrical system requirements in the <br /> Washington State Energy Code,Commercial Provisions. <br /> For questions about this report,contact WSEC Commercial Technical Support at 360-539-5300 or via email at com.techsupport@waenergycodes.com <br /> Where<50%of existing exterior lighting <br /> wattage is replaced;indicate total existing <br /> lighting wattage prior to alteration;include all <br /> new and existing-to-remain luminaires in <br /> t ! <br /> WSEC interior exterior compliance reports; <br /> indicate proposed total exterior lighting f ! <br /> wattage does not exceed total existing wattage <br /> prior to alteration <br /> NO C503.6.2 Interior lighting Where new wiring is installed to serve new general switching <br /> wiring and circuiting interior luminaires and/or luminaires are shown-final switching <br /> alterations relocated to a new circuit;indicate manual by electrical <br /> and automatic lighting controls are provided contractor under their <br /> (as applicable)-manual(C405.2.3); permit ( 1 <br /> occupancy sensor(C405.2.1);light reduction I ; <br /> (C405.2.3);daylight responsive(C405.2.4); <br /> specific application(C405.2.5) <br /> ii i t <br /> Where new wiring is installed to serve new <br /> exterior luminaires and/or luminaires are <br /> relocated to a new circuit;indicate automatic <br /> lighting controls are provided(C405.2.6) <br /> 503.6.3 Lighting panel Where a new interior and/or exterior lighting <br /> alterations I panel is installed or an existing panel is moved <br /> tall new raceway and conductor wirinff), <br /> indicate all applicable lighting controls <br /> requirements apply <br /> C503.6.4 Newly-created rooms Where interior space(s)is reconfigured I I <br /> (permanently installed walls or ceiling-height <br /> partitions)to create new enclosed spaces, <br /> I i <br /> i s indicate all applicable lightingcontrols <br /> requirements apply <br /> YES C504.2 Lighting repairs Identify existing luminaires being upgraded one ex.fixture to <br /> with bulb and/or ballast replacement; remain in the <br /> indicate fixture alteration does not increase restroom <br /> existing fixture wattage <br /> NO C505.1 Change of interior Identify spaces on plans where the building no change of use <br /> space use area type or space use type is being changed <br /> from one type to another per Tables <br /> C405.4.2(1)or(2) <br /> YES j Indicate compliance method(building area or building area-see <br /> space-by-space);include all new and existing- form included <br /> to-remain luminaires in WSEC interior <br /> lighting compliance reports;indicate proposed <br /> • lighting wattage does not exceed maximum <br /> allowed per compliance path <br /> RECEPTACLES <br /> NO C405.10 Controlled identify all controlled and uncontrolled this does not apply <br /> receptacles receptacles on electrical plans in each space in <br /> which they are required;include receptacle <br /> configuration such as spacing between <br /> controlled and uncontrolled,duplex devices, <br /> etc <br /> Page 8/11 <br />