1130 SE EVERETT MALL WAY HOME GOODS 2023-06-22

Lighting, Motor and Electrical Requirements List, pg 3 of 10 2018 WSEC Requirements for Commercial Buildings including Group R2,R3&R4 over 3 stories&all R1-- Administered by©2022 NEEA,All rights reserved The following information is necessary to check a permit application for compliance with the lighting systems,motors and electrical system requirements in the Washington State Energy Code,Commercial Provisions. For questions about this report,contact WSEC Commercial Technical Support at 360-539-5300 or via email at com.techsupport@waenergycodes.com NA C405.2.4 Daylight responsive Indicate on plans lighting zone(s)served by controls daylight responsive controls;indicate that the area served by each control device does not exceeds 2,500 sf NA Identify sidelit and toplit daylight zones that are not provided with daylight sensing controls and the exception(s)that apply NA C405.2.4.1.1 Daylight responsive Indicate on plans the lighting load reduction controls method(continuous dimming,or stepped dimming that provides at least two even steps between 0%-100%of rated power) NA C405.2.4.1 Daylight responsive Indicate that daylight sensing controls are controls configured to completely shut off all controlled lights in the lighting zone YES C405.2.5 Additional controls- Identify spaces and lighting fixtures on plans Elec Sheets Specific application that require specific application lighting lighting controls controls per this section YES C405.2.5, Display and accent Indicate on plans that manual controls are Elec Sheets Item 1 lighting provided that control display,accent lighting and display case lighting independently from both general area lighting and other lighting applications within the same space YES Indicate manual and automatic(occupant Elec Sheets sensor or time switch)lighting control methods C405.2.5, Hotel/motel_nest, ' Indicate method of automatic control- Item 3 rooms vacancy,or captive key control of all installed luminaires and switched receptacles in guest room NA C405.2.5, Supplemental task Indicate method and location of manual and Item 1 lighting automatic shut-off control(occupant sensor or time switch)for supplemental task lighting, including under-shelf or under-cabinet lighting YES C405.2.5, Lighting equipment Indicate on plans that lighting equipment for Elec Sheets Item 1 for sale or sale or demonstration are controlled demonstration independently from both general area lighting and other lighting applications within the same space YES Indicate manual and automatic(occupant Elec Sheets sensor or time switch)lighting control methods NA C405.2.5, Lighting for non- Identify all eligible non-visual lighting Item 4 visual applications applications on plans;indicate that the area served by each control device does not exceeds 4,000 sf NA Indicate on plans that non-visual lighting are controlled independently from both general area lighting and other lighting applications within the same space ( Page 3/10