2721 WETMORE AVE MARQUEE APARTMENTS 2023-06-28

• g ventilation is to be provided at the garage. Mechanical engineering and permitting is to be Bidder Design. 3. Electric vehicle charging locations and infrastructure requirements should be shown on the plans.Section 427 Response: EV stalls have been added. See revised parking calculation sheet A 0.1 and first floor plan sheet A 2.2. 4. The locations of the smoke alarms (smoke detectors within the dwelling units should be shown on the plans.Section 907.2.11.2 Response: See revised sheets A-5.0 through A-5.7 for locations of smoke detectors. Note has been added to indicate smoke detectors are to be hard- wired with battery backup. 5. The locations of the carbon monoxide detectors within the dwelling units should be shown on the plans.Section 915.1 Response: See revised sheets A-5.0 through A-5.7 for locations of carbon monoxide detectors. Note has been added to indicate carbon monoxide detectors are to be hard-wired with battery backup. 6. Emergency responder radio coverage is required within the building (and may prove challenging in the basement garage area).Compliance should be coordinated with the fire marshal's office.Section 916.1 Response: See revised sheet A-0.2 under"Building Code Notes" section. Compliance to be in accordance with IBC Section 918.1 7. There are parts of the structure along Wetmore that are constructed in the right-of-way. We will leave this acceptance to the Public Works Director(and will be addressed in the PW review). Response: We will address any comments from Public Works with a separate response letter. 8. Local exhaust and whole house ventilation requirements should be detailed on the plans. IMC Section 403.8 Response: See revised sheets A-5.0 through A-5.7 for locations of exhaust and ventilation fixtures. Per IBC Section 403.3,the required cubic feet per minute (CFM) ventilation is 100 CFM for kitchens and 50 CFM for bathrooms. 9. Either natural or mechanical ventilation should be provided for the alcove and den spaces—irrespective of openable doors that close off the space from adjacent areas that are provided with natural ventilation.IMC Section 403.8 Response: See revised sheets A-5.0 through A-5.7 for unobstructed opening size and locations at alcoves and dens. Per IMC Section 402.3,unobstructed openings are to be a minimum of 8% the size of the floor area of the room. a. The amounts of ventilation required and provided for each dwelling unit should be shown on the plans.Response: See revised sheets A-5.0 through A-5.7 for natural ventilation size requirements for each unit. Per IMC Section 402.2,trickle vents shall be provided in window frames to allow for a minimum of 4 square inches open area per 10 CFM of required mechanical ventilation. 10.All safety glazing should be specifically identified on the plans/schedule.Section 2406.1 Response: See revised sheet A-3.5.The symbol "S" is added to panes that will be safety glazing.