5117 SEAVIEW WAY 2023-06-22 - Laserfiche WebLink

• • Construction Standards and Specifications for Development shall be submitted to the Public Works Department,showing site grading, paving, landscaping, utilities,storm drainage,temporary construction erosion and sedimentation control (TESC), and any improvements in the public right-of- way. Public Works Department approval of these drawings is required prior to any permits being issued. All improvements shall be completed and approved before the Certificate of Occupancy is issued/final permit approval is granted. 3. The construction plans may be required to be designed from a site survey performed by a licensed State of Washington land surveyor. 4. Temporary erosion and sedimentation control (TESC) measures for construction activity must be operational prior to commencement of any clearing or earthwork.An approved permit and SWPPP for this work is required prior to set-up of TESC measures on-site.All BMPs must comply with City of Everett Design and Construction Standards and Specifications for Development. 5. All exposed ground must be reseeded within 30 days of the completion of construction. If reseeding is not practical due to weather or seasonal restraints,the ground must be covered with mulch as directed by the City Engineer. 6. City streets are to be kept clear of dirt and debris at all times during construction. Dust suppression and street cleaning must occur as directed by the Public Works Inspector. 7. Any grading/fill on this site shall be done so as to not impact the surrounding properties. 8. Stormwater shall be managed in accordance with City of Everett Stormwater Management Standards current at the time the public works/building permit application package is submitted to the City for review. • This project is in the separated storm/sewer area.Currently,the Stormwater code for this area is the Dept.of Ecology's 2014 Stormwater Management Manual for Western Washington (2014 SWMMWW)with Chapter 4 of the City's Design and Construction Standards and Specifications for Development manual (subject to change upon adoption of new manual release). • Chapter 4 of the City's Design and Construction Standards and Specifications for Development manual contains the City's stormwater Standards. • The project will be required to evaluate stormwater in accordance with the Minimum Requirements that this project triggers by following the Flow Charts for Determining Minimum Requirements. 9. Stormwater system development fees in accordance with Ordinance 3632-18 (codified as EMC 14.08.135)and subsequent revision are applicable.These fees are based on square footage of proposed new plus replaced hard surface area. Refer to the Utility&System Development Fee Schedule for estimated fees. The actual charges shall be computed by the Public Works reviewer per the ordinance in effect at the time and according to the information on the approved plans at the time of permit issuance. 10. System development fees for connection to the sewer and water systems in accordance with Ordinance 3632-18(codified as EMC 14.08.135)and subsequent revision are applicable. These charges are based on projected water usage and can be substantial. Applicant is encouraged to obtain a copy of the Ordinance and determine estimated charges prior to permit application. The actual charges shall be computed by the Public Works reviewer per the ordinance in effect at the time and according to the information on the approved plans at the time of permit issuance.These charges are applicable if a new water meter is installed for the garage. If any water or sewer service is proposed but is sharing off of the main service line,no additional water/sewer system development fees will apply. Page 3 of 4 REVI119-019 EVERETT