Laserfiche WebLink
2018 WSEC Requirements for Commercial Buildings including Group R2, R3 & R4 over 3 stories & all R1--MWinistered by ©2022 NEEA, All rights reserved <br />The following information is necessary to check a permit application for compliance with the lighting systems, motors and electrical system requirements in the <br />Washington State Energy Code, Commercial Provisions. <br />For questions about this report, contact WSEC Commercial Technical Support at 360-539-5300 or via email at com.techsupport@waenergycodes.com <br />C405.2.5, <br />Item 5 <br />C405.4.1 <br />C405.4.2 <br />'.41 <br />Indicate on plans that non -visual lighting are <br />controlled independently from both general <br />area lighting and other lighting applications <br />within the same space <br />Indicate nnethod of manual lighting control <br />and applicable automatic lighting control <br />Means of egress Identify on plans egress fixtures that function <br />lighting as both normal and emergency rneans of <br />egress illumination <br />Provide calculation of lighting power density I <br />of total egress lighting <br />If total egress lighting power density is greater <br />than 0.02 W/sq. ft., indicate on plans em-ess <br />fixtures requiring automatic shut-off during <br />unoccupied periods <br />Indicate method of automatic shut-off control <br />Lighting control of <br />Indicate that exempt interior lighting <br />exempt interior <br />equipment and lighting located within spaces <br />lighting i <br />that are eligible for a lighting power <br />i <br />exemption are controlled independently from <br />jnon-exempt <br />and general area lighting <br />Exterior lighting <br />For decorative exterior lighting, indicate on <br />controls <br />plans automatic daylight shut-off controls. or <br />exception taken. <br />For exterior lighting that is not decorative. <br />indicate on plans automatic daylight or time - <br />switch shut-off controls and setback controls, <br />or indicate exception taken <br />I <br />i <br />I <br />C405.5.2 Lighting control of <br />exempt exterior <br />ighting <br />i <br />For lighting requiring setback controls. <br />include control sequence that reduces lighting <br />power by at least 30% between I tam -barn, or <br />from 1 hour after closing to 1 hour before <br />opening. or based upon motion sensor <br />For building facade and landscape lighting, <br />indicate control sequence for shut-off control <br />is based on dawn -to -dusk and business <br />,pening/closing schedule: indicate whether <br />automatic or time switch controls will be <br />provided for this function <br />Indicate that exempt exterior lighting and <br />lighting located within exterior areas/surfaces <br />that eligible for a lighting power exemption <br />are controlled independently from non- <br />exempt exterior lighting <br />—T _ <br />C405.5.4 I Exterior gas -fired I indicate ignition system is a method other <br />lighting appliances then continuously burning pilot light <br />NA C405.2.7 Area controls - Indicate locadon(s) of master control the contractor will <br />Master control switch(es) intended to control multiple provide this if <br />switches and circuit independent switches; circuit breaker may not required <br />j power limit be used as a master control switch <br />Page 4110 <br />