Laserfiche WebLink
2018 WSEC Requirements for Commercial Buildings including Group R2, R3 & R4 over 3 stories & all R1--Wministered by ©2022 NEEA, All rights reserved <br />The following information is necessary to check a permit application for compliance with the lighting systems, motors and electrical system requirements in the <br />Washington State Energy Code, <br />Commercial Provisions. <br />For questions about this report, contact WSEC Commercial Technical Support at 360-539-5300 or via email at com.techsupport@waenergycodes.com <br />For small vertical fenestration assemblies <br />(rough opening less than 10 percent of <br />primary daylight zone floor area) where <br />I daylight responsive controls are not required, i <br />provide fenestration area to daylight zone j <br />floor area calculation(s) <br />C405.2.- <br />Daylight responsive <br />Indicate on plans lighting zone(s) served by j <br />controls <br />i daylight responsive controls; indicate that the <br />area served by each control device does not <br />exceeds 2.500 st <br />j <br />I <br />Identify sidelit and toplit daylight zones thni <br />are not provided with daylight sensing <br />I <br />controls and the exception[:+) that apply <br />C405.2.4.1.1 <br />Daylight responsive <br />Indicate on plans the lighting load reduction <br />controls <br />method (continuous dimming, or stepped <br />dimming that provides at least two even Steps j <br />between 0ak-100% of rated power) <br />I <br />C405.2.4. I <br />Daylight responsive <br />Indicate that daylight sensing conu-ols are j <br />controls <br />( configured to completely shut off all <br />controlled lights in the lighting zone <br />C405.2.5 <br />Additional controls - <br />Identify spaces and lighting fixtures on plans <br />i <br />j <br />Specific application <br />that require specific application lighting <br />l <br />lighting controls <br />i controls per this section <br />C405?.5, <br />Item I <br />Display and accent <br />lighting <br />Indicate on plans that manual controls are <br />provide([ that control display, accent lighting <br />and display case lighting independently from <br />both general area lighting and other lighting <br />applications within the ,sane space <br />Indicate manual and automatic (occupant <br />j sensor or time switch) lighting control <br />1 methods <br />C405.2.5, Hotel/motel guest Indicate method of autontati,c control - <br />Item :3 <br />roonns <br />; vacancy or captive key control of all installed <br />I luminaires and switched receptacles in guest <br />I <br />room <br />_ _-____._-.-__..— <br />I C405.2-5, <br />Supplemental task <br />Indicate method and location of manual and <br />Itetn I <br />lighting <br />automatic shut-off control (occupant sensor or <br />time switch) for supplemental task lighting. <br />including under -shelf or under -cabinet <br />j <br />lighting <br />I C405.2.5, <br />Lighting equipment <br />I Indicate on plans that lighting equipment for <br />j Item I <br />for sale or <br />sale or demonstration are controlled <br />demonstration <br />independently from both general area lighting <br />t and other lighting applications within the <br />sarne space <br />1 <br />Indicate manual and automatic (occupant t <br />1 sensor or time switch) lighting control <br />i methods <br />- -- --- -- — --------------- - - -- - - <br />Lighting for non- Identify all �ligihle nan-visual lighting <br />visual applications i applications on pins; indicate that the area <br />served by each control device does not <br />exceed: 4,000 st <br />5112 <br />Page 3110 <br />