Laserfiche WebLink
I <br />2018 WSEC Requirements for Commercial Buildirigs including Group R2, R3 & R4 over 3 stories & all R1--Wministered by @2022 NEEA, All rights reserved <br />The following information is necessary to check a permit application for compliance with the lighting systems, motors and electrical system requirements in the <br />Washington State Energy Code, Commercial Provisions. <br />For questions about this report, contact WSEC Commercial Technical Support at 360-539-5300 or via email at com.techsupport@waenergycodes.com <br />C405.4 2.l <br />Building Area <br />Demonstrate that total proposed wattage per <br />i Method <br />building area does not exceed maximum j <br />allowed wattage per building area; identity <br />locations of building areas on plans; provide <br />WSEC exterior lighting compliance reports <br />I <br />C405.4.2.2 Space -By -Space <br />Demonstrate that total proposed wattage does <br />Method <br />not exceed maximum allowed wattage; <br />identify locations of space types on plans, j <br />including retail display areas and areas with <br />display, highlight and decorative lighting; <br />provide WSEC exterior lighting compliance <br />r: <br />ADDITIONAL EFFICIENCY CREDITS - REDUCED <br />INTERIOR LIGHTING POWER DENSITY <br />L•k)6.3.1 Reduced interior <br />C406.3.2 lighting power <br />density <br />1'u comply �a;ith udditionul clTiciency credit, <br />demonstrate that total connected interior <br />lighting wattage is 10%, or 20% less than the <br />total maximum allowed lighting wattage for <br />the area the reduced lighting power credit is <br />being applied to: indicate whether lighting <br />power allowance is based on the building area <br />method or space -by -space method; provide <br />WSEC exterior lighting compliance reports <br />C406.3 Reduced interior i For project with dwelling units, to comply I <br />lighting power ( with additional efficiencv credit indicate in I <br />j density -dwelling lighting fixture schedule that lamps within <br />unit lamp efficacy installed interior luminaires have an efficacy <br />rating of at least 65 lumens per watt: include <br />number of lamps and provide calculation.. that <br />idemonstrate at least 95% of lamps have this ! <br />efficacy rating <br />EXTERIOR LIGHTING POWER & EFFICACY <br />k_ I ulutcunrlcctcd Include all luminaires in exterior lighting <br />i exterior lighting fixture schedule; indicate fixture types. lamps, <br />i power ballasts. and manufacturer's watts per fixture <br />for the installed lamp <br />Identify exterior applications eligible for <br />lighting power exemption on plans and in + fj <br />WSEC exterior lighting compliance reports; ; <br />indicate exception applied I I <br />C405.5.3(1) Exterior lighting zone I Indicate building exterior lighting zone as <br />j specified by the AHJ <br />17405.5.1 I Exterior building For building grounds fixtures rated at greater <br />j grounds lighting than 50 watts. indicate rated lamp efficacy tin <br />`lumens per watt] in fixture schedule I' <br />EXTERIOR LIGHTING POWER CALCULATION <br />C405.5. -1 radable alluwances <br />Demonstrate that total proposed tradable <br />surface wattage does not exceed maximum <br />allowed tradable surface wattage (including <br />base site allowance); identify locations of <br />tradable surfaces on plans: provide WSEC <br />exterior lighting compliance reports <br />RI I� <br />Page 6110 <br />