1801 BROADWAY DOMINOS 2025-03-25

• 5. The Floor Plan on Sheets A.2 though A.4 represent the existing and new walls using the same fill pattern per the wall legend. The following comments should be addressed: a. A separate pattern(s)should be used for all new walls to distinguish them from existing construction. See IBC Section 107.2.1. b. Details for the construction of the walls should be provided. The walls should include top and bottom connections to the existing construction for support. The walls and connections should be designed to resist a minimum surface load of 5 psf per IBC Section 1607.15. I�� c. The proposed project appears to include the demolition of interior walls,including finishes in the interior side of the exterior walls. The Existing Plan on Sheet A.1 should specify the ARCHITECTURE demolition of all interior walls and finishes. See also comments in the"Energy"section STUDIO below. NEW PLANS PROVIDE ALL DESIGNATIONS AND DETAILS TO CONVENTIONAL STANDARDS. Fire Protection: 6. The Floor Plans on Sheets A.2 and A.3 show a Type II hood located above an oven and adjacent to an interior wall. The following comments should be addressed: a. It appears that a Type I hood is required. See the"HOOD"definition in IMC Section 202. b. Type I hoods should have a minimum clearance on all sides of 19 inches per IMC Section 507.2.6. Alternatively,adjacent construction should comply with Section 308.4.2. Where reduced clearances are provided,details for the adjacent wall and roof construction,should be included in the architectural plans. c. The project appears to require at least one Type II hood at the dishwashing station. Type II hoods should be specified on the plans where required. See IMC Section 507.3. ARCHITECTURAL AND MECHANICAL PLANS PROVIDE FOR TYPE I OVEN EXHAUST INSTALLATION.NO DISHWASHER IS PROPOSED FOR THIS LOCATION. Accessibility: 7. The sinks in the work area should be accessible. The sink adjacent to the mop sink does not appear to comply. Clearances for all sinks should be shown. Pipe protection should be provided. See IBC Section 1102.1 and ICC A117.1-09 Section 606.1. CLEARANCE SHOWN FOR CLARITY PER ABOVE. 8. The project involves Level 3 Alterations to the building per IEBC Chapter 9. Accessibility improvements per IEBC Section 305.7 should be included in the project. Potentially inaccessible elements include,but are not limited to,the entryway doors,accessible route from the parking to the entryway doors,and parking including striping and signage. Where the building is made to be less than fully-accessible per one of the exceptions,documentation substantiating the limited accessibility improvements should be submitted for review. Where Exception 1 is used,the documentation should itemize the improvements and estimated cost of work associated with each item. Note that new work that does not address a previously-existing deficiencies does not qualify to satisfy this requirement. All ACCESSIBILITY UPDRADES INDICATED IN PLANS. 9. The bathroom on Sheet A.2 is an accessible bathroom. Additional elevations and details for the bathroom should be provided. See IBC Section 1102.1,and references below to ICC A117.1-09 unless noted otherwise. The following comments should be addressed: a. Show accessible clearances per Sections 603,604.3,and 606.2. b. Show centerline dimension for the water closet measured from the side wall per Section 604.2. c. Show centerline dimension for the sink measured from the side wall per IBC Section 107.2.1. d. Provide dimensions for the horizontal and vertical grab bars per Sections 604.5.1 and 604.5.2,and Figures 604.5.1 and 604.5.2. e. Provide water closet seat height dimension per Section 604.4. 1001 SE SANDY BLVD,SUITE 100,PORTLAND,OR 97214 V. 503 552 9079 F 503.241.7055 WWW.GNICHARCH.COM INQUIRY(a�GNICHARCH.COM 23