2706 21ST ST 2024-07-22 - Laserfiche WebLink

Mr. Larry Thibeault Plan Check Number: B2111-005, First Building Review April 7, 2021 5. The project includes exposing the exterior envelope cavities for the entire building. The building is required to be insulated per WSEC Section R503.1.1. Where required, insulation complying with current code should be provided per Table R402.1.1. Attics should be provided with ventilation baffles per Section R402.2.3. 6. The project includes replacement of the existing windows and exterior doors. The required thermal ratings for each type of vertical fenestration should be specified. See WSEC Table R402.1.1. 7. The attic spaces should be provided with access openings per IRC Section R807. 8. The bathrooms and kitchen should specify exhaust fans including the minimum required performance rates per Table M1505.4.4(1). 9. The house is required to have a heating system per IRC Section R303.9. The type and location of the system should be specified. If the system is new, it should be indicated as such in the drawings. Gas appliances are prohibited in the locations specified in Section G2406. 10. The house is required to have a water heating system per IRC Section R306.4. The type and location of the system should be specified. If the system is new, it should be indicated as such in the drawings. Seismic restraints should be provided per Section M1307.2. Gas appliances are prohibited in the locations specified in Section G2406. 11. The project includes construction a new garage/deck tight to the rear wall of the house. Water infiltration will occur between the two structures resulting in deterioration. Weather-barrier details preventing water infiltration should be included in the drawings. See Section R703. 12. Weather-barrier details for the construction of the garage roof/deck should be included in the construction drawings. The roof should be sloped to facilitate drainage and prevent ponding. See Sections R303.1 and R903.4. Structural 1. The construction drawing should structural sections, details, construction schedules, fastening schedules, materials requirements, general notes, special inspection requirements, etc. The drawings should substantiate compliance with the prescriptive requirements of the IRC. See Sections R106.1.1 and R301.1. 2. The project includes additional structural modifications that are not shown, including but not limited to new exterior wall framing, and interior beam and post framing, at the basement level. All new structural work should be shown in the plans. The modified load paths should comply with the prescriptive limitations of the IRC. Alternatively, an engineered analysis and design may be performed per IRC Section R301.1.3; sealed and signed drawings and calculations prepared by a professional engineer licensed in the state of Washington are required per RCW 18.43.010, 18.43.020, and 18.43.070. See Section R301.1. 3200 Cedar Street © 425.257.8810 O everetteps@everettwa.gov Everett,WA 98201 425.257.8857 fax everettwa.gov/permits Page 3 of 5